2 * Copyright 2016 Freescale Semiconductor
4 * SPDX-License-Identifier: GPL-2.0+
7 #ifndef __LS1012A_COMMON_H
8 #define __LS1012A_COMMON_H
10 #define CONFIG_FSL_LAYERSCAPE
13 #include <asm/arch/config.h>
14 #include <asm/arch/stream_id_lsch2.h>
16 #define CONFIG_SUPPORT_RAW_INITRD
18 #define CONFIG_DISPLAY_BOARDINFO_LATE
20 #define CONFIG_SYS_TEXT_BASE 0x40100000
22 #define CONFIG_SYS_CLK_FREQ 125000000
24 #define CONFIG_SKIP_LOWLEVEL_INIT
26 #define CONFIG_SYS_INIT_SP_ADDR (CONFIG_SYS_FSL_OCRAM_BASE + 0xfff0)
27 #define CONFIG_SYS_LOAD_ADDR (CONFIG_SYS_DDR_SDRAM_BASE + 0x10000000)
29 #define CONFIG_SYS_DDR_SDRAM_BASE 0x80000000
30 #define CONFIG_SYS_FSL_DDR_SDRAM_BASE_PHY 0
31 #define CONFIG_SYS_SDRAM_BASE CONFIG_SYS_DDR_SDRAM_BASE
32 #define CONFIG_SYS_DDR_BLOCK2_BASE 0x880000000ULL
34 /* Generic Timer Definitions */
35 #define COUNTER_FREQUENCY 25000000 /* 25MHz */
38 #define CONFIG_LAYERSCAPE_NS_ACCESS
40 /* Size of malloc() pool */
41 #define CONFIG_SYS_MALLOC_LEN (CONFIG_ENV_SIZE + 128 * 1024)
44 #ifdef CONFIG_QSPI_BOOT
45 #define CONFIG_SYS_QE_FW_IN_SPIFLASH
46 #define CONFIG_SYS_FMAN_FW_ADDR 0x400d0000
47 #define CONFIG_ENV_SPI_BUS 0
48 #define CONFIG_ENV_SPI_CS 0
49 #define CONFIG_ENV_SPI_MAX_HZ 1000000
50 #define CONFIG_ENV_SPI_MODE 0x03
51 #define CONFIG_SPI_FLASH_SPANSION
52 #define CONFIG_FSL_SPI_INTERFACE
53 #define CONFIG_SF_DATAFLASH
55 #define CONFIG_FSL_QSPI
56 #define QSPI0_AMBA_BASE 0x40000000
57 #define CONFIG_SPI_FLASH_SPANSION
59 #define FSL_QSPI_FLASH_SIZE SZ_64M
60 #define FSL_QSPI_FLASH_NUM 2
65 #define CONFIG_ENV_OVERWRITE
67 #define CONFIG_ENV_SIZE 0x40000 /* 256KB */
68 #define CONFIG_ENV_OFFSET 0x300000 /* 3MB */
69 #define CONFIG_ENV_SECT_SIZE 0x40000
73 #define CONFIG_SYS_I2C
74 #define CONFIG_SYS_I2C_MXC
75 #define CONFIG_SYS_I2C_MXC_I2C1 /* enable I2C bus 1 */
76 #define CONFIG_SYS_I2C_MXC_I2C2 /* enable I2C bus 2 */
78 #define CONFIG_CONS_INDEX 1
79 #define CONFIG_SYS_NS16550_SERIAL
80 #define CONFIG_SYS_NS16550_REG_SIZE 1
81 #define CONFIG_SYS_NS16550_CLK (get_serial_clock())
83 #define CONFIG_SYS_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, 115200 }
85 #define CONFIG_SYS_HZ 1000
87 #define CONFIG_HWCONFIG
88 #define HWCONFIG_BUFFER_SIZE 128
90 #include <config_distro_defaults.h>
91 #ifndef CONFIG_SPL_BUILD
92 #define BOOT_TARGET_DEVICES(func) \
95 #include <config_distro_bootcmd.h>
98 /* Initial environment variables */
99 #define CONFIG_EXTRA_ENV_SETTINGS \
101 "loadaddr=0x80100000\0" \
102 "kernel_addr=0x100000\0" \
103 "fdt_high=0xffffffffffffffff\0" \
104 "initrd_high=0xffffffffffffffff\0" \
105 "kernel_start=0x1000000\0" \
106 "kernel_load=0xa0000000\0" \
107 "kernel_size=0x2800000\0" \
109 #undef CONFIG_BOOTCOMMAND
110 #define CONFIG_BOOTCOMMAND "sf probe 0:0; sf read $kernel_load "\
111 "$kernel_start $kernel_size && "\
114 /* Monitor Command Prompt */
115 #define CONFIG_SYS_CBSIZE 512 /* Console I/O Buffer Size */
116 #define CONFIG_SYS_LONGHELP
117 #define CONFIG_AUTO_COMPLETE
118 #define CONFIG_SYS_MAXARGS 64 /* max command args */
120 #define CONFIG_PANIC_HANG
121 #define CONFIG_SYS_BOOTM_LEN (64 << 20) /* Increase max gunzip size */
123 #include <asm/arch/soc.h>
125 #endif /* __LS1012A_COMMON_H */