2 * Copyright 2016 Freescale Semiconductor
4 * SPDX-License-Identifier: GPL-2.0+
7 #ifndef __LS1012A_COMMON_H
8 #define __LS1012A_COMMON_H
10 #define CONFIG_FSL_LAYERSCAPE
13 #include <asm/arch/config.h>
14 #include <asm/arch/stream_id_lsch2.h>
16 #define CONFIG_SUPPORT_RAW_INITRD
18 #define CONFIG_DISPLAY_BOARDINFO_LATE
20 #define CONFIG_SYS_CLK_FREQ 125000000
22 #define CONFIG_SKIP_LOWLEVEL_INIT
24 #define CONFIG_SYS_INIT_SP_ADDR (CONFIG_SYS_FSL_OCRAM_BASE + 0xfff0)
25 #define CONFIG_SYS_LOAD_ADDR (CONFIG_SYS_DDR_SDRAM_BASE + 0x10000000)
27 #define CONFIG_SYS_DDR_SDRAM_BASE 0x80000000
28 #define CONFIG_SYS_FSL_DDR_SDRAM_BASE_PHY 0
29 #define CONFIG_SYS_SDRAM_BASE CONFIG_SYS_DDR_SDRAM_BASE
30 #define CONFIG_SYS_DDR_BLOCK2_BASE 0x880000000ULL
32 /* Generic Timer Definitions */
33 #define COUNTER_FREQUENCY 25000000 /* 25MHz */
36 #define CONFIG_LAYERSCAPE_NS_ACCESS
38 /* Size of malloc() pool */
39 #define CONFIG_SYS_MALLOC_LEN (CONFIG_ENV_SIZE + 128 * 1024)
42 #ifdef CONFIG_QSPI_BOOT
43 #define CONFIG_SYS_QE_FW_IN_SPIFLASH
44 #define CONFIG_SYS_FMAN_FW_ADDR 0x400d0000
45 #define CONFIG_ENV_SPI_BUS 0
46 #define CONFIG_ENV_SPI_CS 0
47 #define CONFIG_ENV_SPI_MAX_HZ 1000000
48 #define CONFIG_ENV_SPI_MODE 0x03
49 #define CONFIG_SPI_FLASH_SPANSION
50 #define CONFIG_FSL_SPI_INTERFACE
51 #define CONFIG_SF_DATAFLASH
53 #define CONFIG_FSL_QSPI
54 #define QSPI0_AMBA_BASE 0x40000000
55 #define CONFIG_SPI_FLASH_SPANSION
57 #define FSL_QSPI_FLASH_SIZE SZ_64M
58 #define FSL_QSPI_FLASH_NUM 2
63 #define CONFIG_ENV_OVERWRITE
65 #define CONFIG_ENV_SIZE 0x40000 /* 256KB */
66 #define CONFIG_ENV_OFFSET 0x300000 /* 3MB */
67 #define CONFIG_ENV_SECT_SIZE 0x40000
71 #define CONFIG_SCSI_AHCI_PLAT
73 #define CONFIG_SYS_SATA AHCI_BASE_ADDR
75 #define CONFIG_SYS_SCSI_MAX_SCSI_ID 1
76 #define CONFIG_SYS_SCSI_MAX_LUN 1
77 #define CONFIG_SYS_SCSI_MAX_DEVICE (CONFIG_SYS_SCSI_MAX_SCSI_ID * \
78 CONFIG_SYS_SCSI_MAX_LUN)
81 #define CONFIG_SYS_I2C
82 #define CONFIG_SYS_I2C_MXC
83 #define CONFIG_SYS_I2C_MXC_I2C1 /* enable I2C bus 1 */
84 #define CONFIG_SYS_I2C_MXC_I2C2 /* enable I2C bus 2 */
86 #define CONFIG_CONS_INDEX 1
87 #define CONFIG_SYS_NS16550_SERIAL
88 #define CONFIG_SYS_NS16550_REG_SIZE 1
89 #define CONFIG_SYS_NS16550_CLK (get_serial_clock())
91 #define CONFIG_SYS_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, 115200 }
93 #define CONFIG_SYS_HZ 1000
95 #define CONFIG_HWCONFIG
96 #define HWCONFIG_BUFFER_SIZE 128
98 #include <config_distro_defaults.h>
99 #ifndef CONFIG_SPL_BUILD
100 #define BOOT_TARGET_DEVICES(func) \
101 func(SCSI, scsi, 0) \
104 #include <config_distro_bootcmd.h>
107 /* Initial environment variables */
108 #define CONFIG_EXTRA_ENV_SETTINGS \
110 "loadaddr=0x80100000\0" \
111 "kernel_addr=0x100000\0" \
112 "fdt_high=0xffffffffffffffff\0" \
113 "initrd_high=0xffffffffffffffff\0" \
114 "kernel_start=0x1000000\0" \
115 "kernel_load=0xa0000000\0" \
116 "kernel_size=0x2800000\0" \
118 #undef CONFIG_BOOTCOMMAND
119 #define CONFIG_BOOTCOMMAND "sf probe 0:0; sf read $kernel_load "\
120 "$kernel_start $kernel_size && "\
123 /* Monitor Command Prompt */
124 #define CONFIG_SYS_CBSIZE 512 /* Console I/O Buffer Size */
125 #define CONFIG_SYS_LONGHELP
126 #define CONFIG_AUTO_COMPLETE
127 #define CONFIG_SYS_MAXARGS 64 /* max command args */
129 #define CONFIG_SYS_BOOTM_LEN (64 << 20) /* Increase max gunzip size */
131 #include <asm/arch/soc.h>
133 #endif /* __LS1012A_COMMON_H */