2 * (C) Copyright 2003-2006 Wolfgang Denk, DENX Software Engineering,
5 * SPDX-License-Identifier: GPL-2.0+
12 * High Level Configuration Options
15 #define CONFIG_MPC5200 1 /* This is an MPC5200 CPU */
16 #define CONFIG_V38B 1 /* ...on V38B board */
18 #define CONFIG_SYS_TEXT_BASE 0xFF000000
20 #define CONFIG_SYS_MPC5XXX_CLKIN 33000000 /* ...running at 33.000000MHz */
22 #define CONFIG_RTC_PCF8563 1 /* has PCF8563 RTC */
23 #define CONFIG_MPC5200_DDR 1 /* has DDR SDRAM */
25 #undef CONFIG_HW_WATCHDOG /* don't use watchdog */
27 #define CONFIG_NETCONSOLE 1
29 #define CONFIG_BOARD_EARLY_INIT_R 1 /* do board-specific init */
30 #define CONFIG_BOARD_EARLY_INIT_F 1 /* do board-specific init */
31 #define CONFIG_MISC_INIT_R
33 #define CONFIG_SYS_XLB_PIPELINING 1 /* gives better performance */
35 #define CONFIG_HIGH_BATS 1 /* High BATs supported */
38 * Serial console configuration
40 #define CONFIG_PSC_CONSOLE 1 /* console is on PSC1 */
41 #define CONFIG_BAUDRATE 115200 /* ... at 115200 bps */
42 #define CONFIG_SYS_BAUDRATE_TABLE { 9600, 19200, 38400, 57600, 115200, 230400 }
47 #define SDRAM_DDR 1 /* is DDR */
48 /* Settings for XLB = 132 MHz */
49 #define SDRAM_MODE 0x018D0000
50 #define SDRAM_EMODE 0x40090000
51 #define SDRAM_CONTROL 0x704f0f00
52 #define SDRAM_CONFIG1 0x73722930
53 #define SDRAM_CONFIG2 0x47770000
54 #define SDRAM_TAPDELAY 0x10000000
63 #define CONFIG_MAC_PARTITION 1
64 #define CONFIG_DOS_PARTITION 1
69 #define CONFIG_USB_OHCI
70 #define CONFIG_USB_CLOCK 0x0001BBBB
71 #define CONFIG_USB_CONFIG 0x00001000
76 #define CONFIG_BOOTP_BOOTFILESIZE
77 #define CONFIG_BOOTP_BOOTPATH
78 #define CONFIG_BOOTP_GATEWAY
79 #define CONFIG_BOOTP_HOSTNAME
82 * Command line configuration.
84 #define CONFIG_CMD_IDE
85 #define CONFIG_CMD_DIAG
86 #define CONFIG_CMD_IRQ
87 #define CONFIG_CMD_JFFS2
88 #define CONFIG_CMD_SDRAM
89 #define CONFIG_CMD_DATE
91 #define CONFIG_TIMESTAMP /* Print image info with timestamp */
94 * Boot low with 16 MB Flash
96 #define CONFIG_SYS_LOWBOOT 1
97 #define CONFIG_SYS_LOWBOOT16 1
103 #define CONFIG_PREBOOT "echo;" \
104 "echo Type \\\"run flash_nfs\\\" to mount root filesystem over NFS;" \
107 #undef CONFIG_BOOTARGS
109 #define CONFIG_EXTRA_ENV_SETTINGS \
110 "bootcmd=run net_nfs\0" \
112 "baudrate=115200\0" \
113 "preboot=echo;echo Type \"run flash_nfs\" to mount root " \
114 "filesystem over NFS; echo\0" \
116 "ramargs=setenv bootargs root=/dev/ram rw wdt=off \0" \
117 "addip=setenv bootargs $(bootargs) " \
118 "ip=$(ipaddr):$(serverip):$(gatewayip):" \
119 "$(netmask):$(hostname):$(netdev):off panic=1\0" \
120 "flash_nfs=run nfsargs addip;bootm $(kernel_addr)\0" \
121 "flash_self=run ramargs addip;bootm $(kernel_addr) " \
122 "$(ramdisk_addr)\0" \
123 "net_nfs=tftp 200000 $(bootfile);run nfsargs addip;bootm\0" \
124 "nfsargs=setenv bootargs root=/dev/nfs rw " \
125 "nfsroot=$(serverip):$(rootpath) wdt=off\0" \
128 "rootpath=/opt/eldk-3.1.1/ppc_6xx\0" \
129 "update=prot off ff000000 ff03ffff; era ff000000 ff03ffff; " \
130 "cp.b 200000 ff000000 $(filesize);" \
131 "prot on ff000000 ff03ffff\0" \
132 "load=tftp 200000 $(u-boot)\0" \
133 "netmask=255.255.0.0\0" \
134 "ipaddr=192.168.160.18\0" \
135 "serverip=192.168.1.1\0" \
136 "bootfile=/tftpboot/v38b/uImage\0" \
137 "u-boot=/tftpboot/v38b/u-boot.bin\0" \
140 #define CONFIG_BOOTCOMMAND "run net_nfs"
143 * IPB Bus clocking configuration.
145 #undef CONFIG_SYS_IPBCLK_EQUALS_XLBCLK /* define for 133MHz speed */
150 #define CONFIG_HARD_I2C 1 /* I2C with hardware support */
151 #define CONFIG_SYS_I2C_MODULE 2 /* Select I2C module #1 or #2 */
152 #define CONFIG_SYS_I2C_SPEED 100000 /* 100 kHz */
153 #define CONFIG_SYS_I2C_SLAVE 0x7F
156 * EEPROM configuration
158 #define CONFIG_SYS_I2C_EEPROM_ADDR 0x50 /* 1010000x */
159 #define CONFIG_SYS_I2C_EEPROM_ADDR_LEN 1
160 #define CONFIG_SYS_EEPROM_PAGE_WRITE_BITS 3
161 #define CONFIG_SYS_EEPROM_PAGE_WRITE_DELAY_MS 70
166 #define CONFIG_SYS_I2C_RTC_ADDR 0x51
169 * Flash configuration - use CFI driver
171 #define CONFIG_SYS_FLASH_CFI 1 /* Flash is CFI conformant */
172 #define CONFIG_FLASH_CFI_DRIVER 1 /* Use the common driver */
173 #define CONFIG_SYS_FLASH_CFI_AMD_RESET 1
174 #define CONFIG_SYS_FLASH_BASE 0xFF000000
175 #define CONFIG_SYS_MAX_FLASH_BANKS 1 /* max num of flash banks */
176 #define CONFIG_SYS_FLASH_BANKS_LIST { CONFIG_SYS_FLASH_BASE }
177 #define CONFIG_SYS_FLASH_SIZE 0x01000000 /* 16 MiB */
178 #define CONFIG_SYS_MAX_FLASH_SECT 256 /* max num of sects on one chip */
179 #define CONFIG_SYS_FLASH_USE_BUFFER_WRITE 1 /* flash write speed-up */
182 * Environment settings
184 #define CONFIG_ENV_IS_IN_FLASH 1
185 #define CONFIG_ENV_ADDR (CONFIG_SYS_FLASH_BASE + 0x00040000)
186 #define CONFIG_ENV_SIZE 0x10000
187 #define CONFIG_ENV_SECT_SIZE 0x10000
188 #define CONFIG_ENV_OVERWRITE 1
193 #define CONFIG_SYS_MBAR 0xF0000000
194 #define CONFIG_SYS_SDRAM_BASE 0x00000000
195 #define CONFIG_SYS_DEFAULT_MBAR 0x80000000
197 /* Use SRAM until RAM will be available */
198 #define CONFIG_SYS_INIT_RAM_ADDR MPC5XXX_SRAM
199 #define CONFIG_SYS_INIT_RAM_SIZE MPC5XXX_SRAM_SIZE /* Size of used area in DPRAM */
201 #define CONFIG_SYS_GBL_DATA_OFFSET (CONFIG_SYS_INIT_RAM_SIZE - GENERATED_GBL_DATA_SIZE)
202 #define CONFIG_SYS_INIT_SP_OFFSET CONFIG_SYS_GBL_DATA_OFFSET
204 #define CONFIG_SYS_MONITOR_BASE CONFIG_SYS_TEXT_BASE
205 #if (CONFIG_SYS_MONITOR_BASE < CONFIG_SYS_FLASH_BASE)
206 # define CONFIG_SYS_RAMBOOT 1
209 #define CONFIG_SYS_MONITOR_LEN (256 << 10) /* Reserve 256kB for Monitor */
210 #define CONFIG_SYS_MALLOC_LEN (128 << 10) /* Reserve 128kB for malloc() */
211 #define CONFIG_SYS_BOOTMAPSZ (8 << 20) /* Linux initial memory map */
214 * Ethernet configuration
216 #define CONFIG_MPC5xxx_FEC 1
217 #define CONFIG_MPC5xxx_FEC_MII100
218 #define CONFIG_PHY_ADDR 0x00
224 #define CONFIG_SYS_GPS_PORT_CONFIG 0x90001404
227 * Miscellaneous configurable options
229 #define CONFIG_SYS_LONGHELP /* undef to save memory */
230 #if defined(CONFIG_CMD_KGDB)
231 #define CONFIG_SYS_CBSIZE 1024 /* Console I/O Buffer Size */
233 #define CONFIG_SYS_CBSIZE 256 /* Console I/O Buffer Size */
235 #define CONFIG_SYS_PBSIZE (CONFIG_SYS_CBSIZE+sizeof(CONFIG_SYS_PROMPT)+16) /* Print Buffer Size */
236 #define CONFIG_SYS_MAXARGS 16 /* max number of command args */
237 #define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE /* Boot Argument Buffer Size */
239 #define CONFIG_SYS_MEMTEST_START 0x00100000 /* memtest works on */
240 #define CONFIG_SYS_MEMTEST_END 0x00f00000 /* 1 ... 15 MB in DRAM */
242 #define CONFIG_SYS_LOAD_ADDR 0x100000 /* default load address */
244 #define CONFIG_SYS_CACHELINE_SIZE 32 /* For MPC5xxx CPUs */
245 #if defined(CONFIG_CMD_KGDB)
246 # define CONFIG_SYS_CACHELINE_SHIFT 5 /* log base 2 of the above value */
250 * Various low-level settings
252 #define CONFIG_SYS_HID0_INIT HID0_ICE | HID0_ICFI
253 #define CONFIG_SYS_HID0_FINAL HID0_ICE
255 #define CONFIG_SYS_BOOTCS_START CONFIG_SYS_FLASH_BASE
256 #define CONFIG_SYS_BOOTCS_SIZE CONFIG_SYS_FLASH_SIZE
257 #define CONFIG_SYS_BOOTCS_CFG 0x00047801
258 #define CONFIG_SYS_CS0_START CONFIG_SYS_FLASH_BASE
259 #define CONFIG_SYS_CS0_SIZE CONFIG_SYS_FLASH_SIZE
261 #define CONFIG_SYS_CS_BURST 0x00000000
262 #define CONFIG_SYS_CS_DEADCYCLE 0x33333333
264 #define CONFIG_SYS_RESET_ADDRESS 0xff000000
267 * IDE/ATA (supports IDE harddisk)
269 #undef CONFIG_IDE_8xx_PCCARD /* Don't use IDE with PC Card Adapter */
270 #undef CONFIG_IDE_8xx_DIRECT /* Direct IDE not supported */
271 #undef CONFIG_IDE_LED /* LED for ide not supported */
273 #define CONFIG_IDE_RESET /* reset for ide supported */
274 #define CONFIG_IDE_PREINIT
276 #define CONFIG_SYS_IDE_MAXBUS 1 /* max. 1 IDE bus */
277 #define CONFIG_SYS_IDE_MAXDEVICE 1 /* max. 1 drive per IDE bus */
279 #define CONFIG_SYS_ATA_IDE0_OFFSET 0x0000
281 #define CONFIG_SYS_ATA_BASE_ADDR MPC5XXX_ATA
283 #define CONFIG_SYS_ATA_DATA_OFFSET (0x0060) /* data I/O offset */
285 #define CONFIG_SYS_ATA_REG_OFFSET (CONFIG_SYS_ATA_DATA_OFFSET) /* normal register accesses offset */
287 #define CONFIG_SYS_ATA_ALT_OFFSET (0x005C) /* alternate registers offset */
289 #define CONFIG_SYS_ATA_STRIDE 4 /* Interval between registers */
295 #define CONFIG_SYS_LED_BASE MPC5XXX_GPT7_ENABLE /* Timer 7 GPIO */
297 typedef unsigned int led_id_t;
299 #define __led_toggle(_msk) \
301 *((volatile long *) (CONFIG_SYS_LED_BASE)) ^= (_msk); \
304 #define __led_set(_msk, _st) \
307 *((volatile long *) (CONFIG_SYS_LED_BASE)) &= ~(_msk); \
309 *((volatile long *) (CONFIG_SYS_LED_BASE)) |= (_msk); \
312 #define __led_init(_msk, st) \
314 *((volatile long *) (CONFIG_SYS_LED_BASE)) |= 0x34; \
316 #endif /* __ASSEMBLY__ */
318 #endif /* __CONFIG_H */