avoid duplicating the logic in the TPS65090 regulator driver for
enabling/disabling an LDO.
+config I2C_SET_DEFAULT_BUS_NUM
+ bool "Set default I2C bus number"
+ depends on DM_I2C
+ help
+ Set default number of I2C bus to be accessed. This option provides
+ behaviour similar to old (i.e. pre DM) I2C bus driver.
+
+config I2C_DEFAULT_BUS_NUMBER
+ hex "I2C default bus number"
+ depends on I2C_SET_DEFAULT_BUS_NUM
+ default 0x0
+ help
+ Number of default I2C bus to use
+
config DM_I2C_GPIO
bool "Enable Driver Model for software emulated I2C bus driver"
depends on DM_I2C && DM_GPIO
enable status register. This config option can be enabled in such
cases.
+config SYS_I2C_ASPEED
+ bool "Aspeed I2C Controller"
+ depends on DM_I2C && ARCH_ASPEED
+ help
+ Say yes here to select Aspeed I2C Host Controller. The driver
+ supports AST2500 and AST2400 controllers, but is very limited.
+ Only single master mode is supported and only byte-by-byte
+ synchronous reads and writes are supported, no Pool Buffers or DMA.
+
config SYS_I2C_INTEL
bool "Intel I2C/SMBUS driver"
depends on DM_I2C
the I2C API meaning that any I2C operations will immediately fail
for now.
+config SYS_I2C_IMX_LPI2C
+ bool "NXP i.MX LPI2C driver"
+ depends on ARCH_MX7ULP
+ help
+ Add support for the NXP i.MX LPI2C driver.
+
config SYS_I2C_MXC
bool "NXP i.MX I2C driver"
depends on MX6