powerpc/p2041rdb: add NAND and NAND boot support

[u-boot] / README

diff --git a/README b/README
index c98afa74b18f68a866a4283bc5c0785374e6fd3f..43074cf65f8327e98f1c007f889fe9c69a6869b8 100644 (file)
--- a/README
+++ b/README
@@ -374,6 +374,12 @@ The following options need to be configured:
                Defines the string to utilize when trying to match PCIe device
                tree nodes for the given platform.
 
                Defines the string to utilize when trying to match PCIe device
                tree nodes for the given platform.
 

+- Generic CPU options:
+               CONFIG_SYS_BIG_ENDIAN, CONFIG_SYS_LITTLE_ENDIAN
+
+               Defines the endianess of the CPU. Implementation of those
+               values is arch specific.
+

 - Intel Monahans options:
                CONFIG_SYS_MONAHANS_RUN_MODE_OSC_RATIO
 
 - Intel Monahans options:
                CONFIG_SYS_MONAHANS_RUN_MODE_OSC_RATIO
 


@@ -3493,7 +3499,7 @@ is done by typing:
        make NAME_config
 
 where "NAME_config" is the name of one of the existing configu-
        make NAME_config
 
 where "NAME_config" is the name of one of the existing configu-

-rations; see the main Makefile for supported names.
+rations; see boards.cfg for supported names.

 
 Note: for some board special configuration names may exist; check if
       additional information is available from the board vendor; for
 
 Note: for some board special configuration names may exist; check if
       additional information is available from the board vendor; for


@@ -3548,10 +3554,8 @@ to port U-Boot to your hardware platform. To do this, follow these
 steps:
 
 1.  Add a new configuration option for your board to the toplevel
 steps:
 
 1.  Add a new configuration option for your board to the toplevel

-    "Makefile" and to the "MAKEALL" script, using the existing
-    entries as examples. Note that here and at many other places
-    boards and other names are listed in alphabetical sort order. Please
-    keep this order.
+    "boards.cfg" file, using the existing entries as examples.
+    Follow the instructions there to keep the boards in order.

 2.  Create a new directory to hold your board specific code. Add any
     files you need. In your board directory, you will need at least
     the "Makefile", a "<board>.c", "flash.c" and "u-boot.lds".
 2.  Create a new directory to hold your board specific code. Add any
     files you need. In your board directory, you will need at least
     the "Makefile", a "<board>.c", "flash.c" and "u-boot.lds".