+ CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR,
+ CONFIG_SYS_U_BOOT_MAX_SIZE_SECTORS,
+ CONFIG_SYS_MMC_SD_FAT_BOOT_PARTITION
+ Address, size and partition on the MMC to load U-Boot from
+ when the MMC is being used in raw mode.
+
+ CONFIG_SPL_FAT_SUPPORT
+ Support for fs/fat/libfat.o in SPL binary
+
+ CONFIG_SPL_FAT_LOAD_PAYLOAD_NAME
+ Filename to read to load U-Boot when reading from FAT
+
+ CONFIG_SPL_MPC83XX_WAIT_FOR_NAND
+ Set this for NAND SPL on PPC mpc83xx targets, so that
+ start.S waits for the rest of the SPL to load before
+ continuing (the hardware starts execution after just
+ loading the first page rather than the full 4K).
+
+ CONFIG_SPL_NAND_BASE
+ Include nand_base.c in the SPL. Requires
+ CONFIG_SPL_NAND_DRIVERS.
+
+ CONFIG_SPL_NAND_DRIVERS
+ SPL uses normal NAND drivers, not minimal drivers.
+
+ CONFIG_SPL_NAND_ECC
+ Include standard software ECC in the SPL
+
+ CONFIG_SPL_NAND_SIMPLE
+ Support for NAND boot using simple NAND drivers that
+ expose the cmd_ctrl() interface.
+
+ CONFIG_SYS_NAND_5_ADDR_CYCLE, CONFIG_SYS_NAND_PAGE_COUNT,
+ CONFIG_SYS_NAND_PAGE_SIZE, CONFIG_SYS_NAND_OOBSIZE,
+ CONFIG_SYS_NAND_BLOCK_SIZE, CONFIG_SYS_NAND_BAD_BLOCK_POS,
+ CONFIG_SYS_NAND_ECCPOS, CONFIG_SYS_NAND_ECCSIZE,
+ CONFIG_SYS_NAND_ECCBYTES
+ Defines the size and behavior of the NAND that SPL uses
+ to read U-Boot
+
+ CONFIG_SYS_NAND_U_BOOT_OFFS
+ Location in NAND to read U-Boot from
+
+ CONFIG_SYS_NAND_U_BOOT_DST
+ Location in memory to load U-Boot to
+
+ CONFIG_SYS_NAND_U_BOOT_SIZE
+ Size of image to load
+
+ CONFIG_SYS_NAND_U_BOOT_START
+ Entry point in loaded image to jump to
+
+ CONFIG_SYS_NAND_HW_ECC_OOBFIRST
+ Define this if you need to first read the OOB and then the
+ data. This is used for example on davinci plattforms.
+
+ CONFIG_SPL_OMAP3_ID_NAND
+ Support for an OMAP3-specific set of functions to return the
+ ID and MFR of the first attached NAND chip, if present.
+