-/******************************************************************************
- * Routine: delay
- * Description: spinning delay to use before udelay works
- *****************************************************************************/
-static inline void delay(unsigned long loops)
+static const struct gpio_bank gpio_bank_34xx[6] = {
+ { (void *)OMAP34XX_GPIO1_BASE, METHOD_GPIO_24XX },
+ { (void *)OMAP34XX_GPIO2_BASE, METHOD_GPIO_24XX },
+ { (void *)OMAP34XX_GPIO3_BASE, METHOD_GPIO_24XX },
+ { (void *)OMAP34XX_GPIO4_BASE, METHOD_GPIO_24XX },
+ { (void *)OMAP34XX_GPIO5_BASE, METHOD_GPIO_24XX },
+ { (void *)OMAP34XX_GPIO6_BASE, METHOD_GPIO_24XX },
+};
+
+const struct gpio_bank *const omap_gpio_bank = gpio_bank_34xx;
+
+#ifdef CONFIG_SPL_BUILD
+/*
+* We use static variables because global data is not ready yet.
+* Initialized data is available in SPL right from the beginning.
+* We would not typically need to save these parameters in regular
+* U-Boot. This is needed only in SPL at the moment.
+*/
+u32 omap3_boot_device = BOOT_DEVICE_NAND;
+
+/* auto boot mode detection is not possible for OMAP3 - hard code */
+u32 spl_boot_mode(void)
+{
+ switch (spl_boot_device()) {
+ case BOOT_DEVICE_MMC2:
+ return MMCSD_MODE_RAW;
+ case BOOT_DEVICE_MMC1:
+ return MMCSD_MODE_FAT;
+ break;
+ default:
+ puts("spl: ERROR: unknown device - can't select boot mode\n");
+ hang();
+ }
+}
+
+u32 spl_boot_device(void)
+{
+ return omap3_boot_device;
+}
+
+int board_mmc_init(bd_t *bis)