+config HAVE_VBT
+ bool "Add a Video BIOS Table (VBT) image"
+ depends on HAVE_FSP
+ help
+ Select this option if you have a Video BIOS Table (VBT) image that
+ you would like to add to your ROM. This is normally required if you
+ are using an Intel FSP firmware that is complaint with spec 1.1 or
+ later to initialize the integrated graphics device (IGD).
+
+ Video BIOS Table, or VBT, provides platform and board specific
+ configuration information to the driver that is not discoverable
+ or available through other means. By other means the most used
+ method here is to read EDID table from the attached monitor, over
+ Display Data Channel (DDC) using two pin I2C serial interface. VBT
+ configuration is related to display hardware and is available via
+ the ACPI OpRegion or, on older systems, in the PCI ROM (Option ROM).
+
+config VBT_FILE
+ string "Video BIOS Table (VBT) image filename"
+ depends on HAVE_VBT
+ default "vbt.bin"
+ help
+ The filename of the file to use as Video BIOS Table (VBT) image
+ in the board directory.
+
+config VBT_ADDR
+ hex "Video BIOS Table (VBT) image location"
+ depends on HAVE_VBT
+ default 0xfff90000
+ help
+ The location of Video BIOS Table (VBT) image in the SPI flash. For
+ example, base address of 0xfff90000 indicates that the image will
+ be put at offset 0x90000 from the beginning of a 1MB flash device.
+
+config VIDEO_FSP
+ bool "Enable FSP framebuffer driver support"
+ depends on HAVE_VBT && DM_VIDEO
+ help
+ Turn on this option to enable a framebuffer driver when U-Boot is
+ using Video BIOS Table (VBT) image for FSP firmware to initialize
+ the integrated graphics device.
+
+config ROM_TABLE_ADDR
+ hex
+ default 0xf0000
+ help
+ All x86 tables happen to like the address range from 0x0f0000
+ to 0x100000. We use 0xf0000 as the starting address to store
+ those tables, including PIRQ routing table, Multi-Processor
+ table and ACPI table.
+
+config ROM_TABLE_SIZE
+ hex
+ default 0x10000
+