]> git.sur5r.net Git - u-boot/blobdiff - doc/README.falcon
arm: mx6: tqma6: fix build for WRU-IV baseboard
[u-boot] / doc / README.falcon
index bccf6c95c869388ae6824a50ccb25e378d925104..e9f8a7583c721cd96eb364ff23d591c0284c70b3 100644 (file)
@@ -31,9 +31,10 @@ informed to load it before running the kernel.
 To boot the kernel, these steps under a Falcon-aware U-Boot are required:
 
 1. Boot the board into U-Boot.
 To boot the kernel, these steps under a Falcon-aware U-Boot are required:
 
 1. Boot the board into U-Boot.
-Use the "spl export" command to generate the kernel parameters area or the DT.
-U-Boot runs as when it boots the kernel, but stops before passing the control
-to the kernel.
+After loading the desired legacy-format kernel image into memory (and DT as
+well, if used), use the "spl export" command to generate the kernel parameters
+area or the DT.  U-Boot runs as when it boots the kernel, but stops before
+passing the control to the kernel.
 
 2. Save the prepared snapshot into persistent media.
 The address where to save it must be configured into board configuration
 
 2. Save the prepared snapshot into persistent media.
 The address where to save it must be configured into board configuration
@@ -89,6 +90,10 @@ mode.  In this case the following variables may be supported:
 boot_os :              Set to yes/Yes/true/True/1 to enable booting to OS,
                        any other value to fall back to U-Boot (including
                        unset)
 boot_os :              Set to yes/Yes/true/True/1 to enable booting to OS,
                        any other value to fall back to U-Boot (including
                        unset)
+falcon_args_file :     Filename to load as the 'args' portion of falcon mode
+                       rather than the hard-coded value.
+falcon_image_file :    Filename to load as the OS image portion of falcon
+                       mode rather than the hard-coded value.
 
 Using spl command
 -----------------
 
 Using spl command
 -----------------