- Dave Peverley, MPC-Data Limited
- http://www.mpc-data.co.uk
+ Dave Peverley, MPC-Data Limited
+ http://www.mpc-data.co.uk
-The serial console has been set up to run from the DB9 connector on the
-P2 board at 115200 baud, 8 data bits, no stop bits, 1 parity bit.
+The serial console has been set up to run from the DB9 connector on the
+P2 board at 115200 baud, 8 data bits, no stop bits, 1 parity bit.
-2) Set up the P2 to boot from CS3, and connect with CCS. Reset the CPU
- and run the "init_mmu" GEL script.
+2) Set up the P2 to boot from CS3, and connect with CCS. Reset the CPU
+ and run the "init_mmu" GEL script.
At this point, u-boot should run and you will see the boot menu on your
serial terminal. You can then load the u-boot image to memory :
# loadb 0x10000000
At this point, u-boot should run and you will see the boot menu on your
serial terminal. You can then load the u-boot image to memory :
# loadb 0x10000000
Alternative flash option :
Sometimes, if you've been silly, you can get the board into a state where
whats in flash has upset the board so much that you can no longer connect
Alternative flash option :
Sometimes, if you've been silly, you can get the board into a state where
whats in flash has upset the board so much that you can no longer connect
- board can have checksum errors or stall. This appears to be an issue
- with the lan91c96.c driver, and can normally be worked around by
+ board can have checksum errors or stall. This appears to be an issue
+ with the lan91c96.c driver, and can normally be worked around by