+#define CONFIG_SYS_MSC2_VAL 0x123C6CDC /* extra bus, LAN controller */
+
+/* MDCNFG: SDRAM Configuration Register
+ *
+ * [31:29] 000 - reserved
+ * [28] 0 - no SA1111 compatiblity mode
+ * [27] 0 - latch return data with return clock
+ * [26] 0 - alternate addressing for pair 2/3
+ * [25:24] 00 - timings
+ * [23] 0 - internal banks in lower partition 2/3 (not used)
+ * [22:21] 00 - row address bits for partition 2/3 (not used)
+ * [20:19] 00 - column address bits for partition 2/3 (not used)
+ * [18] 0 - SDRAM partition 2/3 width is 32 bit
+ * [17] 0 - SDRAM partition 3 disabled
+ * [16] 0 - SDRAM partition 2 disabled
+ * [15:13] 000 - reserved
+ * [12] 1 - SA1111 compatiblity mode
+ * [11] 1 - latch return data with return clock
+ * [10] 0 - no alternate addressing for pair 0/1
+ * [09:08] 01 - tRP=2*MemClk CL=2 tRCD=2*MemClk tRAS=5*MemClk tRC=8*MemClk
+ * [7] 1 - 4 internal banks in lower partition pair
+ * [06:05] 10 - 13 row address bits for partition 0/1
+ * [04:03] 01 - 9 column address bits for partition 0/1
+ * [02] 0 - SDRAM partition 0/1 width is 32 bit
+ * [01] 0 - disable SDRAM partition 1
+ * [00] 1 - enable SDRAM partition 0
+ */
+/* use the configuration above but disable partition 0 */
+#define CONFIG_SYS_MDCNFG_VAL 0x000019c8
+
+/* MDREFR: SDRAM Refresh Control Register
+ *
+ * [32:26] 0 - reserved
+ * [25] 0 - K2FREE: not free running
+ * [24] 0 - K1FREE: not free running
+ * [23] 1 - K0FREE: not free running
+ * [22] 0 - SLFRSH: self refresh disabled
+ * [21] 0 - reserved
+ * [20] 0 - APD: no auto power down
+ * [19] 0 - K2DB2: SDCLK2 is MemClk
+ * [18] 0 - K2RUN: disable SDCLK2
+ * [17] 0 - K1DB2: SDCLK1 is MemClk
+ * [16] 1 - K1RUN: enable SDCLK1
+ * [15] 1 - E1PIN: SDRAM clock enable
+ * [14] 1 - K0DB2: SDCLK0 is MemClk
+ * [13] 0 - K0RUN: disable SDCLK0
+ * [12] 1 - E0PIN: disable SDCKE0
+ * [11:00] 000000011000 - (64ms/8192)*MemClkFreq/32 = 24
+ */
+#define CONFIG_SYS_MDREFR_VAL 0x0081D018
+
+/* MDMRS: Mode Register Set Configuration Register
+ *
+ * [31] 0 - reserved
+ * [30:23] 00000000- MDMRS2: SDRAM2/3 MRS Value. (not used)
+ * [22:20] 000 - MDCL2: SDRAM2/3 Cas Latency. (not used)
+ * [19] 0 - MDADD2: SDRAM2/3 burst Type. Fixed to sequential. (not used)
+ * [18:16] 010 - MDBL2: SDRAM2/3 burst Length. Fixed to 4. (not used)
+ * [15] 0 - reserved
+ * [14:07] 00000000- MDMRS0: SDRAM0/1 MRS Value.
+ * [06:04] 010 - MDCL0: SDRAM0/1 Cas Latency.
+ * [03] 0 - MDADD0: SDRAM0/1 burst Type. Fixed to sequential.
+ * [02:00] 010 - MDBL0: SDRAM0/1 burst Length. Fixed to 4.
+ */
+#define CONFIG_SYS_MDMRS_VAL 0x00020022