-/*
- * The ARM boot monitor initializes the board.
- * However, the default U-Boot code also performs the initialization.
- * If desired, this can be prevented by defining SKIP_LOWLEVEL_INIT
- * - see documentation supplied with board for details of how to choose the
- * image to run at reset/power up
- * e.g. whether the ARM Boot Monitor runs before U-Boot
-
-#define CONFIG_SKIP_LOWLEVEL_INIT
-
- */
-
-/*
- * The ARM boot monitor does not relocate U-Boot.
- * However, the default U-Boot code performs the relocation check,
- * and may relocate the code if the memory map is changed.
- * If necessary this can be prevented by defining SKIP_RELOCATE_UBOOT
-
-#define SKIP_CONFIG_RELOCATE_UBOOT
-
- */
-/*-----------------------------------------------------------------------
- * There are various dependencies on the core module (CM) fitted
- * Users should refer to their CM user guide
- * - when porting adjust u-boot/Makefile accordingly
- * to define the necessary CONFIG_ s for the CM involved
- * see e.g. cp_926ejs_config
- */
-
-#include "armcoremodule.h"
-
-/*
- * If CONFIG_SKIP_LOWLEVEL_INIT is not defined &
- * the core module has a CM_INIT register
- * then the U-Boot initialisation code will
- * e.g. ARM Boot Monitor or pre-loader is repeated once
- * (to re-initialise any existing CM_INIT settings to safe values).
- *
- * This is usually not the desired behaviour since the platform
- * will either reboot into the ARM monitor (or pre-loader)
- * or continuously cycle thru it without U-Boot running,
- * depending upon the setting of Integrator/CP switch S2-4.
- *
- * However it may be needed if Integrator/CP switch S2-1
- * is set OFF to boot direct into U-Boot.
- * In that case comment out the line below.
-#undef CONFIG_CM_INIT
- */
-