+extern char lcd_is_enabled;
+
+extern int lcd_line_length;
+
+extern struct vidinfo panel_info;
+
+void lcd_ctrl_init(void *lcdbase);
+void lcd_enable(void);
+int board_splash_screen_prepare(void);
+
+/* setcolreg used in 8bpp/16bpp; initcolregs used in monochrome */
+void lcd_setcolreg(ushort regno, ushort red, ushort green, ushort blue);
+void lcd_initcolregs(void);
+
+int lcd_getfgcolor(void);
+
+/* gunzip_bmp used if CONFIG_VIDEO_BMP_GZIP */
+struct bmp_image *gunzip_bmp(unsigned long addr, unsigned long *lenp);
+int bmp_display(ulong addr, int x, int y);
+
+/**
+ * Set whether we need to flush the dcache when changing the LCD image. This
+ * defaults to off.
+ *
+ * @param flush non-zero to flush cache after update, 0 to skip
+ */
+void lcd_set_flush_dcache(int flush);
+
+#if defined CONFIG_MPC823
+/*
+ * LCD controller stucture for MPC823 CPU
+ */
+typedef struct vidinfo {
+ ushort vl_col; /* Number of columns (i.e. 640) */
+ ushort vl_row; /* Number of rows (i.e. 480) */
+ ushort vl_width; /* Width of display area in millimeters */
+ ushort vl_height; /* Height of display area in millimeters */
+
+ /* LCD configuration register */
+ u_char vl_clkp; /* Clock polarity */
+ u_char vl_oep; /* Output Enable polarity */
+ u_char vl_hsp; /* Horizontal Sync polarity */
+ u_char vl_vsp; /* Vertical Sync polarity */
+ u_char vl_dp; /* Data polarity */
+ u_char vl_bpix; /* Bits per pixel, 0 = 1, 1 = 2, 2 = 4, 3 = 8 */
+ u_char vl_lbw; /* LCD Bus width, 0 = 4, 1 = 8 */
+ u_char vl_splt; /* Split display, 0 = single-scan, 1 = dual-scan */
+ u_char vl_clor; /* Color, 0 = mono, 1 = color */
+ u_char vl_tft; /* 0 = passive, 1 = TFT */
+
+ /* Horizontal control register. Timing from data sheet */
+ ushort vl_wbl; /* Wait between lines */
+
+ /* Vertical control register */
+ u_char vl_vpw; /* Vertical sync pulse width */
+ u_char vl_lcdac; /* LCD AC timing */
+ u_char vl_wbf; /* Wait between frames */
+} vidinfo_t;
+
+#elif defined(CONFIG_CPU_PXA25X) || defined(CONFIG_CPU_PXA27X) || \
+ defined CONFIG_CPU_MONAHANS
+/*
+ * PXA LCD DMA descriptor
+ */
+struct pxafb_dma_descriptor {
+ u_long fdadr; /* Frame descriptor address register */
+ u_long fsadr; /* Frame source address register */
+ u_long fidr; /* Frame ID register */
+ u_long ldcmd; /* Command register */
+};
+
+/*
+ * PXA LCD info
+ */
+struct pxafb_info {
+
+ /* Misc registers */
+ u_long reg_lccr3;
+ u_long reg_lccr2;
+ u_long reg_lccr1;
+ u_long reg_lccr0;
+ u_long fdadr0;
+ u_long fdadr1;
+
+ /* DMA descriptors */
+ struct pxafb_dma_descriptor * dmadesc_fblow;
+ struct pxafb_dma_descriptor * dmadesc_fbhigh;
+ struct pxafb_dma_descriptor * dmadesc_palette;
+
+ u_long screen; /* physical address of frame buffer */
+ u_long palette; /* physical address of palette memory */
+ u_int palette_size;
+};
+
+/*
+ * LCD controller stucture for PXA CPU
+ */
+typedef struct vidinfo {
+ ushort vl_col; /* Number of columns (i.e. 640) */
+ ushort vl_row; /* Number of rows (i.e. 480) */
+ ushort vl_width; /* Width of display area in millimeters */
+ ushort vl_height; /* Height of display area in millimeters */
+
+ /* LCD configuration register */
+ u_char vl_clkp; /* Clock polarity */
+ u_char vl_oep; /* Output Enable polarity */
+ u_char vl_hsp; /* Horizontal Sync polarity */
+ u_char vl_vsp; /* Vertical Sync polarity */
+ u_char vl_dp; /* Data polarity */
+ u_char vl_bpix; /* Bits per pixel, 0 = 1, 1 = 2, 2 = 4, 3 = 8, 4 = 16 */
+ u_char vl_lbw; /* LCD Bus width, 0 = 4, 1 = 8 */
+ u_char vl_splt; /* Split display, 0 = single-scan, 1 = dual-scan */
+ u_char vl_clor; /* Color, 0 = mono, 1 = color */
+ u_char vl_tft; /* 0 = passive, 1 = TFT */
+
+ /* Horizontal control register. Timing from data sheet */
+ ushort vl_hpw; /* Horz sync pulse width */
+ u_char vl_blw; /* Wait before of line */
+ u_char vl_elw; /* Wait end of line */
+
+ /* Vertical control register. */
+ u_char vl_vpw; /* Vertical sync pulse width */
+ u_char vl_bfw; /* Wait before of frame */
+ u_char vl_efw; /* Wait end of frame */
+
+ /* PXA LCD controller params */
+ struct pxafb_info pxa;
+} vidinfo_t;
+
+#elif defined(CONFIG_ATMEL_LCD) || defined(CONFIG_ATMEL_HLCD)
+
+typedef struct vidinfo {
+ ushort vl_col; /* Number of columns (i.e. 640) */
+ ushort vl_row; /* Number of rows (i.e. 480) */
+ u_long vl_clk; /* pixel clock in ps */
+
+ /* LCD configuration register */
+ u_long vl_sync; /* Horizontal / vertical sync */
+ u_long vl_bpix; /* Bits per pixel, 0 = 1, 1 = 2, 2 = 4, 3 = 8, 4 = 16 */
+ u_long vl_tft; /* 0 = passive, 1 = TFT */
+ u_long vl_cont_pol_low; /* contrast polarity is low */
+ u_long vl_clk_pol; /* clock polarity */
+
+ /* Horizontal control register. */
+ u_long vl_hsync_len; /* Length of horizontal sync */
+ u_long vl_left_margin; /* Time from sync to picture */
+ u_long vl_right_margin; /* Time from picture to sync */
+
+ /* Vertical control register. */
+ u_long vl_vsync_len; /* Length of vertical sync */
+ u_long vl_upper_margin; /* Time from sync to picture */
+ u_long vl_lower_margin; /* Time from picture to sync */
+
+ u_long mmio; /* Memory mapped registers */
+} vidinfo_t;
+
+#elif defined(CONFIG_EXYNOS_FB)
+
+enum {
+ FIMD_RGB_INTERFACE = 1,
+ FIMD_CPU_INTERFACE = 2,
+};
+
+enum exynos_fb_rgb_mode_t {
+ MODE_RGB_P = 0,
+ MODE_BGR_P = 1,
+ MODE_RGB_S = 2,
+ MODE_BGR_S = 3,
+};
+
+typedef struct vidinfo {
+ ushort vl_col; /* Number of columns (i.e. 640) */
+ ushort vl_row; /* Number of rows (i.e. 480) */
+ ushort vl_width; /* Width of display area in millimeters */
+ ushort vl_height; /* Height of display area in millimeters */
+
+ /* LCD configuration register */
+ u_char vl_freq; /* Frequency */
+ u_char vl_clkp; /* Clock polarity */
+ u_char vl_oep; /* Output Enable polarity */
+ u_char vl_hsp; /* Horizontal Sync polarity */
+ u_char vl_vsp; /* Vertical Sync polarity */
+ u_char vl_dp; /* Data polarity */
+ u_char vl_bpix; /* Bits per pixel */
+
+ /* Horizontal control register. Timing from data sheet */
+ u_char vl_hspw; /* Horz sync pulse width */
+ u_char vl_hfpd; /* Wait before of line */
+ u_char vl_hbpd; /* Wait end of line */
+
+ /* Vertical control register. */
+ u_char vl_vspw; /* Vertical sync pulse width */
+ u_char vl_vfpd; /* Wait before of frame */
+ u_char vl_vbpd; /* Wait end of frame */
+ u_char vl_cmd_allow_len; /* Wait end of frame */
+
+ void (*cfg_gpio)(void);
+ void (*backlight_on)(unsigned int onoff);
+ void (*reset_lcd)(void);
+ void (*lcd_power_on)(void);
+ void (*cfg_ldo)(void);
+ void (*enable_ldo)(unsigned int onoff);
+ void (*mipi_power)(void);
+ void (*backlight_reset)(void);
+
+ unsigned int win_id;
+ unsigned int init_delay;
+ unsigned int power_on_delay;
+ unsigned int reset_delay;
+ unsigned int interface_mode;
+ unsigned int mipi_enabled;
+ unsigned int dp_enabled;
+ unsigned int cs_setup;
+ unsigned int wr_setup;
+ unsigned int wr_act;
+ unsigned int wr_hold;
+ unsigned int logo_on;
+ unsigned int logo_width;
+ unsigned int logo_height;
+ unsigned long logo_addr;
+ unsigned int rgb_mode;
+ unsigned int resolution;
+
+ /* parent clock name(MPLL, EPLL or VPLL) */
+ unsigned int pclk_name;
+ /* ratio value for source clock from parent clock. */
+ unsigned int sclk_div;
+
+ unsigned int dual_lcd_enabled;
+} vidinfo_t;
+
+void init_panel_info(vidinfo_t *vid);
+
+#else
+
+typedef struct vidinfo {
+ ushort vl_col; /* Number of columns (i.e. 160) */
+ ushort vl_row; /* Number of rows (i.e. 100) */
+
+ u_char vl_bpix; /* Bits per pixel, 0 = 1 */
+
+ ushort *cmap; /* Pointer to the colormap */
+
+ void *priv; /* Pointer to driver-specific data */
+} vidinfo_t;
+
+#endif /* CONFIG_MPC823, CONFIG_CPU_PXA25X, CONFIG_MCC200, CONFIG_ATMEL_LCD */
+
+extern vidinfo_t panel_info;
+
+/* Video functions */
+