+#if defined(CONFIG_MPC83xx)
+#define CONFIG_SYS_FSL_USB_ADDR CONFIG_SYS_MPC83xx_USB_ADDR
+#elif defined(CONFIG_MPC85xx)
+#define CONFIG_SYS_FSL_USB_ADDR CONFIG_SYS_MPC85xx_USB_ADDR
+#elif defined(CONFIG_MPC512X)
+#define CONFIG_SYS_FSL_USB_ADDR CONFIG_SYS_MPC512x_USB_ADDR
+#endif
+
+/*
+ * USB Registers
+ */
+struct usb_ehci {
+ u32 id; /* 0x000 - Identification register */
+ u32 hwgeneral; /* 0x004 - General hardware parameters */
+ u32 hwhost; /* 0x008 - Host hardware parameters */
+ u32 hwdevice; /* 0x00C - Device hardware parameters */
+ u32 hwtxbuf; /* 0x010 - TX buffer hardware parameters */
+ u32 hwrxbuf; /* 0x014 - RX buffer hardware parameters */
+ u8 res1[0x68];
+ u32 gptimer0_ld; /* 0x080 - General Purpose Timer 0 load value */
+ u32 gptimer0_ctrl; /* 0x084 - General Purpose Timer 0 control */
+ u32 gptimer1_ld; /* 0x088 - General Purpose Timer 1 load value */
+ u32 gptimer1_ctrl; /* 0x08C - General Purpose Timer 1 control */
+ u32 sbuscfg; /* 0x090 - System Bus Interface Control */
+ u8 res2[0x6C];
+ u8 caplength; /* 0x100 - Capability Register Length */
+ u8 res3[0x1];
+ u16 hciversion; /* 0x102 - Host Interface Version */
+ u32 hcsparams; /* 0x104 - Host Structural Parameters */
+ u32 hccparams; /* 0x108 - Host Capability Parameters */
+ u8 res4[0x14];
+ u32 dciversion; /* 0x120 - Device Interface Version */
+ u32 dciparams; /* 0x124 - Device Controller Params */
+ u8 res5[0x18];
+ u32 usbcmd; /* 0x140 - USB Command */
+ u32 usbsts; /* 0x144 - USB Status */
+ u32 usbintr; /* 0x148 - USB Interrupt Enable */
+ u32 frindex; /* 0x14C - USB Frame Index */
+ u8 res6[0x4];
+ u32 perlistbase; /* 0x154 - Periodic List Base
+ - USB Device Address */
+ u32 ep_list_addr; /* 0x158 - Next Asynchronous List
+ - End Point Address */
+ u8 res7[0x4];
+ u32 burstsize; /* 0x160 - Programmable Burst Size */
+#define FSL_EHCI_TXPBURST(X) ((X) << 8)
+#define FSL_EHCI_RXPBURST(X) (X)
+ u32 txfilltuning; /* 0x164 - Host TT Transmit
+ pre-buffer packet tuning */
+ u8 res8[0x8];
+ u32 ulpi_viewpoint; /* 0x170 - ULPI Reister Access */
+ u8 res9[0xc];
+ u32 config_flag; /* 0x180 - Configured Flag Register */
+ u32 portsc; /* 0x184 - Port status/control */
+ u8 res10[0x1C];
+ u32 otgsc; /* 0x1a4 - Oo-The-Go status and control */
+ u32 usbmode; /* 0x1a8 - USB Device Mode */
+ u32 epsetupstat; /* 0x1ac - End Point Setup Status */
+ u32 epprime; /* 0x1b0 - End Point Init Status */
+ u32 epflush; /* 0x1b4 - End Point De-initlialize */
+ u32 epstatus; /* 0x1b8 - End Point Status */
+ u32 epcomplete; /* 0x1bc - End Point Complete */
+ u32 epctrl0; /* 0x1c0 - End Point Control 0 */
+ u32 epctrl1; /* 0x1c4 - End Point Control 1 */
+ u32 epctrl2; /* 0x1c8 - End Point Control 2 */
+ u32 epctrl3; /* 0x1cc - End Point Control 3 */
+ u32 epctrl4; /* 0x1d0 - End Point Control 4 */
+ u32 epctrl5; /* 0x1d4 - End Point Control 5 */
+ u8 res11[0x28];
+ u32 usbgenctrl; /* 0x200 - USB General Control */
+ u32 isiphyctrl; /* 0x204 - On-Chip PHY Control */
+ u8 res12[0x1F8];
+ u32 snoop1; /* 0x400 - Snoop 1 */
+ u32 snoop2; /* 0x404 - Snoop 2 */
+ u32 age_cnt_limit; /* 0x408 - Age Count Threshold */
+ u32 prictrl; /* 0x40c - Priority Control */
+ u32 sictrl; /* 0x410 - System Interface Control */
+ u8 res13[0xEC];
+ u32 control; /* 0x500 - Control */
+ u8 res14[0xafc];
+};
+
+/*
+ * For MXC SOCs
+ */
+
+/* values for portsc field */
+#define MXC_EHCI_PHY_LOW_POWER_SUSPEND (1 << 23)
+#define MXC_EHCI_FORCE_FS (1 << 24)
+#define MXC_EHCI_UTMI_8BIT (0 << 28)
+#define MXC_EHCI_UTMI_16BIT (1 << 28)
+#define MXC_EHCI_SERIAL (1 << 29)
+#define MXC_EHCI_MODE_UTMI (0 << 30)
+#define MXC_EHCI_MODE_PHILIPS (1 << 30)
+#define MXC_EHCI_MODE_ULPI (2 << 30)
+#define MXC_EHCI_MODE_SERIAL (3 << 30)
+
+/* values for flags field */
+#define MXC_EHCI_INTERFACE_DIFF_UNI (0 << 0)
+#define MXC_EHCI_INTERFACE_DIFF_BI (1 << 0)
+#define MXC_EHCI_INTERFACE_SINGLE_UNI (2 << 0)
+#define MXC_EHCI_INTERFACE_SINGLE_BI (3 << 0)
+#define MXC_EHCI_INTERFACE_MASK (0xf)
+
+#define MXC_EHCI_POWER_PINS_ENABLED (1 << 5)
+#define MXC_EHCI_PWR_PIN_ACTIVE_HIGH (1 << 6)
+#define MXC_EHCI_OC_PIN_ACTIVE_LOW (1 << 7)
+#define MXC_EHCI_TTL_ENABLED (1 << 8)
+
+#define MXC_EHCI_INTERNAL_PHY (1 << 9)
+#define MXC_EHCI_IPPUE_DOWN (1 << 10)
+#define MXC_EHCI_IPPUE_UP (1 << 11)
+
+/* Board-specific initialization */
+int board_ehci_hcd_init(int port);
+
+/* CPU-specific abstracted-out IOMUX init */
+#ifdef CONFIG_MX51
+void setup_iomux_usb_h1(void);
+void setup_iomux_usb_h2(void);
+#endif
+