- * The next three instructions were added after discovering a problem while using an oscilloscope. For the V8
- * SAM-ICE dongle (and likely other j-link device variants), the reset line to the target microprocessor was found to
- * cycle only intermittently during emulator startup (even after encountering the downstream reset instruction later
- * in the code). This was found to create two issues: 1) In general it is a bad practice to not reset a CPU to a known
- * state when starting an emulator and 2) something critical happens inside the dongle when it does the first read
- * following a new USB session. Keeping the processor in reset during the first read collecting version information
- * seems to prevent errant "J-Link command EMU_CMD_VERSION failed" issues.
+ * The next three instructions were added after discovering a problem
+ * while using an oscilloscope.
+ * For the V8 SAM-ICE dongle (and likely other j-link device variants),
+ * the reset line to the target microprocessor was found to cycle only
+ * intermittently during emulator startup (even after encountering the
+ * downstream reset instruction later in the code).
+ * This was found to create two issues:
+ * 1) In general it is a bad practice to not reset a CPU to a known
+ * state when starting an emulator and
+ * 2) something critical happens inside the dongle when it does the
+ * first read following a new USB session.
+ * Keeping the processor in reset during the first read collecting
+ * version information seems to prevent errant
+ * "J-Link command EMU_CMD_VERSION failed" issues.