Enable L2 cache parity/ECC error checking

[u-boot] / README

diff --git a/README b/README
index 862bb3e6c12d43d3c93eead4d772dd1f8d9eca68..3012dcdc16a4b6ac987fecb002e0140d71079893 100644 (file)
--- a/README
+++ b/README
@@ -201,7 +201,6 @@ Directory Hierarchy:
       /mpc5xx          Files specific to Freescale MPC5xx CPUs
       /mpc5xxx         Files specific to Freescale MPC5xxx CPUs
       /mpc8xx          Files specific to Freescale MPC8xx CPUs
-      /mpc8220         Files specific to Freescale MPC8220 CPUs
       /mpc824x         Files specific to Freescale MPC824x CPUs
       /mpc8260         Files specific to Freescale MPC8260 CPUs
       /mpc85xx         Files specific to Freescale MPC85xx CPUs
@@ -898,6 +897,7 @@ The following options need to be configured:
                CONFIG_CMD_SF           * Read/write/erase SPI NOR flash
                CONFIG_CMD_SHA1SUM        print sha1 memory digest
                                          (requires CONFIG_CMD_MEMORY)
+               CONFIG_CMD_SOFTSWITCH   * Soft switch setting command for BF60x
                CONFIG_CMD_SOURCE         "source" command Support
                CONFIG_CMD_SPI          * SPI serial bus support
                CONFIG_CMD_TFTPSRV      * TFTP transfer in server mode
@@ -930,6 +930,13 @@ The following options need to be configured:
 
                XXX - this list needs to get updated!
 
+- Regular expression support:
+               CONFIG_REGEX
+                If this variable is defined, U-Boot is linked against
+                the SLRE (Super Light Regular Expression) library,
+                which adds regex support to some commands, as for
+                example "env grep" and "setexpr".
+
 - Device tree:
                CONFIG_OF_CONTROL
                If this variable is defined, U-Boot will use a device tree
@@ -2989,6 +2996,12 @@ FIT uImage format:
                use an arch-specific makefile fragment instead, for
                example if more than one image needs to be produced.
 
+               CONFIG_FIT_SPL_PRINT
+               Printing information about a FIT image adds quite a bit of
+               code to SPL. So this is normally disabled in SPL. Use this
+               option to re-enable it. This will affect the output of the
+               bootm command when booting a FIT image.
+
 Modem Support:
 --------------
 
@@ -5050,7 +5063,7 @@ On some platforms, it's possible to boot Linux zImage. This is done
 using the "bootz" command. The syntax of "bootz" command is the same
 as the syntax of "bootm" command.
 
-Note, defining the CONFIG_SUPPORT_INITRD_RAW allows user to supply
+Note, defining the CONFIG_SUPPORT_RAW_INITRD allows user to supply
 kernel with raw initrd images. The syntax is slightly different, the
 address of the initrd must be augmented by it's size, in the following
 format: "<initrd addres>:<initrd size>".