CONFIG_CMD_CRC32 * crc32
CONFIG_CMD_DHCP * DHCP support
CONFIG_CMD_DIAG * Diagnostics
- CONFIG_CMD_DS4510 * ds4510 I2C gpio commands
- CONFIG_CMD_DS4510_INFO * ds4510 I2C info command
- CONFIG_CMD_DS4510_MEM * ds4510 I2C eeprom/sram commansd
- CONFIG_CMD_DS4510_RST * ds4510 I2C rst command
- CONFIG_CMD_DTT * Digital Therm and Thermostat
CONFIG_CMD_ECHO echo arguments
CONFIG_CMD_EDITENV edit env variable
- CONFIG_CMD_EEPROM * EEPROM read/write support
- CONFIG_CMD_EEPROM_LAYOUT* EEPROM layout aware commands
CONFIG_CMD_ELF * bootelf, bootvx
- CONFIG_CMD_ENV_CALLBACK * display details about env callbacks
- CONFIG_CMD_ENV_FLAGS * display details about env flags
CONFIG_CMD_ENV_EXISTS * check existence of env variable
CONFIG_CMD_EXPORTENV * export the environment
CONFIG_CMD_EXT2 * ext2 command support
that work for multiple fs types
CONFIG_CMD_FS_UUID * Look up a filesystem UUID
CONFIG_CMD_SAVEENV saveenv
- CONFIG_CMD_FDC * Floppy Disk Support
CONFIG_CMD_FAT * FAT command support
CONFIG_CMD_FLASH flinfo, erase, protect
CONFIG_CMD_FPGA FPGA device initialization support
- CONFIG_CMD_FUSE * Device fuse support
CONFIG_CMD_GETTIME * Get time since boot
CONFIG_CMD_GO * the 'go' command (exec code)
CONFIG_CMD_GREPENV * search environment
If defined, then this indicates the I2C bus number for the RTC.
If not defined, then U-Boot assumes that RTC is on I2C bus 0.
- CONFIG_SYS_DTT_BUS_NUM
-
- If defined, then this indicates the I2C bus number for the DTT.
- If not defined, then U-Boot assumes that DTT is on I2C bus 0.
-
- CONFIG_SYS_I2C_DTT_ADDR:
-
- If defined, specifies the I2C address of the DTT device.
- If not defined, then U-Boot uses predefined value for
- specified DTT device.
-
CONFIG_SOFT_I2C_READ_REPEATED_START
defining this will force the i2c_read() function in
Specify the number of FPGA devices to support.
- CONFIG_CMD_FPGA_LOADMK
-
- Enable support for fpga loadmk command
-
- CONFIG_CMD_FPGA_LOADP
-
- Enable support for fpga loadp command - load partial bitstream
-
- CONFIG_CMD_FPGA_LOADBP
-
- Enable support for fpga loadbp command - load partial bitstream
- (Xilinx only)
-
CONFIG_SYS_FPGA_PROG_FEEDBACK
Enable printing of hash marks during FPGA configuration.
Enable the hash verify command (hash -v). This adds to code
size a little.
- CONFIG_SHA1 - This option enables support of hashing using SHA1
- algorithm. The hash is calculated in software.
- CONFIG_SHA256 - This option enables support of hashing using
- SHA256 algorithm. The hash is calculated in software.
- CONFIG_SHA_HW_ACCEL - This option enables hardware acceleration
- for SHA1/SHA256 hashing.
- This affects the 'hash' command and also the
- hash_lookup_algo() function.
- CONFIG_SHA_PROG_HW_ACCEL - This option enables
- hardware-acceleration for SHA1/SHA256 progressive hashing.
- Data can be streamed in a block at a time and the hashing
- is performed in hardware.
-
Note: There is also a sha1sum command, which should perhaps
be deprecated in favour of 'hash sha1'.