net: rtl8169: Add support for RTL-8168/8111g

[u-boot] / README

diff --git a/README b/README
index e7cd1bcb436dff45feb2be387eaee30323cc15ae..5af345b0860959c94451383b8389a833f83ec159 100644 (file)
--- a/README
+++ b/README
@@ -409,6 +409,10 @@ The following options need to be configured:
                Enables a workaround for IFC erratum A003399. It is only
                requred during NOR boot.
 
+               CONFIG_A008044_WORKAROUND
+               Enables a workaround for T1040/T1042 erratum A008044. It is only
+               requred during NAND boot and valid for Rev 1.0 SoC revision
+
                CONFIG_SYS_FSL_CORENET_SNOOPVEC_COREONLY
 
                This is the value to write into CCSR offset 0x18600
@@ -783,6 +787,13 @@ The following options need to be configured:
                Board code has addition modification that it wants to make
                to the flat device tree before handing it off to the kernel
 
+               CONFIG_OF_SYSTEM_SETUP
+
+               Other code has addition modification that it wants to make
+               to the flat device tree before handing it off to the kernel.
+               This causes ft_system_setup() to be called before booting
+               the kernel.
+
                CONFIG_OF_BOOT_CPU
 
                This define fills in the correct boot CPU in the boot
@@ -3510,7 +3521,7 @@ FIT uImage format:
                to 128 or 256, although it does not have to be power of 2).
 
                default: 4096
-               
+
                CONFIG_MTD_UBI_BEB_LIMIT
                This option specifies the maximum bad physical eraseblocks UBI
                expects on the MTD device (per 1024 eraseblocks). If the
@@ -3650,10 +3661,13 @@ FIT uImage format:
 
                CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR,
                CONFIG_SYS_U_BOOT_MAX_SIZE_SECTORS,
-               CONFIG_SYS_MMC_SD_FS_BOOT_PARTITION
-               Address, size and partition on the MMC to load U-Boot from
+               Address and partition on the MMC to load U-Boot from
                when the MMC is being used in raw mode.
 
+               CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_PARTITION
+               Partition on the MMC to load U-Boot from when the MMC is being
+               used in raw mode
+
                CONFIG_SYS_MMCSD_RAW_MODE_KERNEL_SECTOR
                Sector to load kernel uImage from when MMC is being
                used in raw mode (for Falcon mode)
@@ -3664,6 +3678,10 @@ FIT uImage format:
                parameters from when MMC is being used in raw mode
                (for falcon mode)
 
+               CONFIG_SYS_MMCSD_FS_BOOT_PARTITION
+               Partition on the MMC to load U-Boot from when the MMC is being
+               used in fs mode
+
                CONFIG_SPL_FAT_SUPPORT
                Support for fs/fat/libfat.o in SPL binary
 
@@ -3989,6 +4007,25 @@ Configuration Settings:
                boards which do not use the full malloc in SPL (which is
                enabled with CONFIG_SYS_SPL_MALLOC_START).
 
+- CONFIG_SYS_NONCACHED_MEMORY:
+               Size of non-cached memory area. This area of memory will be
+               typically located right below the malloc() area and mapped
+               uncached in the MMU. This is useful for drivers that would
+               otherwise require a lot of explicit cache maintenance. For
+               some drivers it's also impossible to properly maintain the
+               cache. For example if the regions that need to be flushed
+               are not a multiple of the cache-line size, *and* padding
+               cannot be allocated between the regions to align them (i.e.
+               if the HW requires a contiguous array of regions, and the
+               size of each region is not cache-aligned), then a flush of
+               one region may result in overwriting data that hardware has
+               written to another region in the same cache-line. This can
+               happen for example in network drivers where descriptors for
+               buffers are typically smaller than the CPU cache-line (e.g.
+               16 bytes vs. 32 or 64 bytes).
+
+               Non-cached memory is only supported on 32-bit ARM at present.
+
 - CONFIG_SYS_BOOTM_LEN:
                Normally compressed uImages are limited to an
                uncompressed size of 8 MBytes. If this is not enough,