arm: socfpga: Fix with the correct polling on bit is set

[u-boot] / README

diff --git a/README b/README
index 5cf90a482a8f2056e1fc69b75aa825bffe5ae19f..6f98e09e680d539246c279a18059c2f38ad7ce10 100644 (file)
--- a/README
+++ b/README
@@ -812,14 +812,6 @@ The following options need to be configured:
                CONFIG_AT91_HW_WDT_TIMEOUT
                specify the timeout in seconds. default 2 seconds.
 
-- U-Boot Version:
-               CONFIG_VERSION_VARIABLE
-               If this variable is defined, an environment variable
-               named "ver" is created by U-Boot showing the U-Boot
-               version as printed by the "version" command.
-               Any change to this variable will be reverted at the
-               next reset.
-
 - Real-Time Clock:
 
                When CONFIG_CMD_DATE is selected, the type of the RTC
@@ -1420,10 +1412,6 @@ The following options need to be configured:
                be at least 4MB.
 
 - MII/PHY support:
-               CONFIG_PHY_ADDR
-
-               The address of PHY on MII bus.
-
                CONFIG_PHY_CLOCK_FREQ (ppc4xx)
 
                The clock frequency of the MII bus
@@ -2217,12 +2205,6 @@ The following options need to be configured:
                the environment like the "source" command or the
                boot command first.
 
-               CONFIG_ENV_VARS_UBOOT_RUNTIME_CONFIG
-
-               Define this in order to add variables describing certain
-               run-time determined information about the hardware to the
-               environment.  These will be named board_name, board_rev.
-
                CONFIG_DELAY_ENVIRONMENT
 
                Normally the environment is loaded when the board is
@@ -2486,12 +2468,6 @@ FIT uImage format:
                kernel. Needed for UBI support.
 
 - UBI support
-               CONFIG_UBI_SILENCE_MSG
-
-               Make the verbose messages from UBI stop printing.  This leaves
-               warnings and errors enabled.
-
-
                CONFIG_MTD_UBI_WL_THRESHOLD
                This parameter defines the maximum difference between the highest
                erase counter value and the lowest erase counter value of eraseblocks
@@ -2553,12 +2529,6 @@ FIT uImage format:
                Enable UBI fastmap debug
                default: 0
 
-- UBIFS support
-               CONFIG_UBIFS_SILENCE_MSG
-
-               Make the verbose messages from UBIFS stop printing.  This leaves
-               warnings and errors enabled.
-
 - SPL framework
                CONFIG_SPL
                Enable building of SPL globally.
@@ -2818,9 +2788,6 @@ Configuration Settings:
                Begin and End addresses of the area used by the
                simple memory test.
 
-- CONFIG_SYS_ALT_MEMTEST:
-               Enable an alternate, more extensive memory test.
-
 - CONFIG_SYS_MEMTEST_SCRATCH:
                Scratch address used by the alternate memory test
                You only need to set this if address zero isn't writeable
@@ -3446,9 +3413,6 @@ Low Level (hardware related) configuration options:
                If defined, the x86 reset vector code is included. This is not
                needed when U-Boot is running from Coreboot.
 
-- CONFIG_SPL_AM33XX_ENABLE_RTC32K_OSC:
-               Enables the RTC32K OSC on AM33xx based plattforms
-
 - CONFIG_SYS_NAND_NO_SUBPAGE_WRITE
                Option to disable subpage write in NAND driver
                driver that uses this: