tree is available in the global data as gd->fdt_blob.
U-Boot needs to get its device tree from somewhere. This can
- be done using one of the two options below:
+ be done using one of the three options below:
CONFIG_OF_EMBED
If this variable is defined, U-Boot will embed a device tree
still use the individual files if you need something more
exotic.
+ CONFIG_OF_BOARD
+ If this variable is defined, U-Boot will use the device tree
+ provided by the board at runtime instead of embedding one with
+ the image. Only boards defining board_fdt_blob_setup() support
+ this option (see include/fdtdec.h file).
+
- Watchdog:
CONFIG_WATCHDOG
If this variable is defined, it enables watchdog
- approved multibus support
- better i2c mux support
- ** Please consider updating your I2C driver now. **
-
- These enable legacy I2C serial bus commands. Defining
- CONFIG_HARD_I2C will include the appropriate I2C driver
- for the selected CPU.
-
- This will allow you to use i2c commands at the u-boot
- command line (as long as you set CONFIG_CMD_I2C in
- CONFIG_COMMANDS) and communicate with i2c based realtime
- clock chips. See common/cmd_i2c.c for a description of the
- command line interface.
+ ** CONFIG_HARD_I2C is now being removed **
- CONFIG_HARD_I2C selects a hardware I2C controller.
-
- There are several other quantities that must also be
- defined when you define CONFIG_HARD_I2C.
+----under removal:
In both cases you will need to define CONFIG_SYS_I2C_SPEED
to be the frequency (in Hz) at which you wish your i2c bus
If defined, the x86 reset vector code is included. This is not
needed when U-Boot is running from Coreboot.
-- CONFIG_SYS_MPUCLK
- Defines the MPU clock speed (in MHz).
-
- NOTE : currently only supported on AM335x platforms.
-
- CONFIG_SPL_AM33XX_ENABLE_RTC32K_OSC:
Enables the RTC32K OSC on AM33xx based plattforms