In this mode, a single differential clock is used to supply
clocks to the sysclock, ddrclock and usbclock.
+ CONFIG_SYS_CPC_REINIT_F
+ This CONFIG is defined when the CPC is configured as SRAM at the
+ time of U-boot entry and is required to be re-initialized.
+
- Generic CPU options:
CONFIG_SYS_BIG_ENDIAN, CONFIG_SYS_LITTLE_ENDIAN
The default command configuration includes all commands
except those marked below with a "*".
+ CONFIG_CMD_AES AES 128 CBC encrypt/decrypt
CONFIG_CMD_ASKENV * ask for env variable
CONFIG_CMD_BDI bdinfo
CONFIG_CMD_BEDBUG * Include BedBug Debugger
CONFIG_CMD_CDP * Cisco Discover Protocol support
CONFIG_CMD_MFSL * Microblaze FSL support
CONFIG_CMD_XIMG Load part of Multi Image
-
+ CONFIG_CMD_UUID * Generate random UUID or GUID string
EXAMPLE: If you want all functions except of network
support you can write:
this to the maximum filesize (in bytes) for the buffer.
Default is 4 MiB if undefined.
+ DFU_DEFAULT_POLL_TIMEOUT
+ Poll timeout [ms], is the timeout a device can send to the
+ host. The host must wait for this timeout before sending
+ a subsequent DFU_GET_STATUS request to the device.
+
+ DFU_MANIFEST_POLL_TIMEOUT
+ Poll timeout [ms], which the device sends to the host when
+ entering dfuMANIFEST state. Host waits this timeout, before
+ sending again an USB request to the device.
+
- Journaling Flash filesystem support:
CONFIG_JFFS2_NAND, CONFIG_JFFS2_NAND_OFF, CONFIG_JFFS2_NAND_SIZE,
CONFIG_JFFS2_NAND_DEV
are used to identify the storage device (NOR flash, SPI, etc) and the address
within that device.
-- CONFIG_SYS_QE_FMAN_FW_ADDR
- The address in the storage device where the firmware is located. The
+- CONFIG_SYS_FMAN_FW_ADDR
+ The address in the storage device where the FMAN microcode is located. The
+ meaning of this address depends on which CONFIG_SYS_QE_FW_IN_xxx macro
+ is also specified.
+
+- CONFIG_SYS_QE_FW_ADDR
+ The address in the storage device where the QE microcode is located. The
meaning of this address depends on which CONFIG_SYS_QE_FW_IN_xxx macro
is also specified.