CONFIG_SH_ETHER_CACHE_WRITEBACK
If this option is set, the driver enables cache flush.
+- PWM Support:
+ CONFIG_PWM_IMX
+ Support for PWM modul on the imx6.
+
- TPM Support:
CONFIG_TPM
Support TPM devices.
memories can be connected with a given cs line.
currently Xilinx Zynq qspi support these type of connections.
+ CONFIG_SYS_SPI_ST_ENABLE_WP_PIN
+ enable the W#/Vpp signal to disable writing to the status
+ register on ST MICRON flashes like the N25Q128.
+ The status register write enable/disable bit, combined with
+ the W#/VPP signal provides hardware data protection for the
+ device as follows: When the enable/disable bit is set to 1,
+ and the W#/VPP signal is driven LOW, the status register
+ nonvolatile bits become read-only and the WRITE STATUS REGISTER
+ operation will not execute. The only way to exit this
+ hardware-protected mode is to drive W#/VPP HIGH.
+
- SystemACE Support:
CONFIG_SYSTEMACE
- CONFIG_SYS_MALLOC_LEN:
Size of DRAM reserved for malloc() use.
+- CONFIG_SYS_MALLOC_F_LEN
+ Size of the malloc() pool for use before relocation. If
+ this is defined, then a very simple malloc() implementation
+ will become available before relocation. The address is just
+ below the global data, and the stack is moved down to make
+ space.
+
+ This feature allocates regions with increasing addresses
+ within the region. calloc() is supported, but realloc()
+ is not available. free() is supported but does nothing.
+ The memory will be freed (or in fact just forgotton) when
+ U-Boot relocates itself.
+
+ Pre-relocation malloc() is only supported on sandbox
+ at present but is fairly easy to enable for other archs.
+
- CONFIG_SYS_BOOTM_LEN:
Normally compressed uImages are limited to an
uncompressed size of 8 MBytes. If this is not enough,