Switch from per-driver to common definition of bin2bcd and bcd2bin

[u-boot] / README

diff --git a/README b/README
index ca415d38b1f7f3c41e54653331a4ba9b4f4a30a1..cf3867dcf39d68c739711593937a530b4fcfb7f1 100644 (file)
--- a/README
+++ b/README
@@ -603,7 +603,6 @@ The following options need to be configured:
                CONFIG_CMD_DATE         * support for RTC, date/time...
                CONFIG_CMD_DHCP         * DHCP support
                CONFIG_CMD_DIAG         * Diagnostics
-               CONFIG_CMD_DOC          * Disk-On-Chip Support
                CONFIG_CMD_DS4510       * ds4510 I2C gpio commands
                CONFIG_CMD_DS4510_INFO  * ds4510 I2C info command
                CONFIG_CMD_DS4510_MEM   * ds4510 I2C eeprom/sram commansd
@@ -630,6 +629,8 @@ The following options need to be configured:
                CONFIG_CMD_KGDB         * kgdb
                CONFIG_CMD_LOADB          loadb
                CONFIG_CMD_LOADS          loads
+               CONFIG_CMD_MD5SUM         print md5 message digest
+                                         (requires CONFIG_CMD_MEMORY and CONFIG_MD5)
                CONFIG_CMD_MEMORY         md, mm, nm, mw, cp, cmp, crc, base,
                                          loop, loopw, mtest
                CONFIG_CMD_MISC           Misc functions like sleep etc
@@ -653,6 +654,8 @@ The following options need to be configured:
                                          (requires CONFIG_CMD_I2C)
                CONFIG_CMD_SETGETDCR      Support for DCR Register access
                                          (4xx only)
+               CONFIG_CMD_SHA1           print sha1 memory digest
+                                         (requires CONFIG_CMD_MEMORY)
                CONFIG_CMD_SOURCE         "source" command Support
                CONFIG_CMD_SPI          * SPI serial bus support
                CONFIG_CMD_USB          * USB support
@@ -1074,6 +1077,26 @@ The following options need to be configured:
                allows for a "silent" boot where a splash screen is
                loaded very quickly after power-on.
 
+               CONFIG_SPLASH_SCREEN_ALIGN
+
+               If this option is set the splash image can be freely positioned
+               on the screen. Environment variable "splashpos" specifies the
+               position as "x,y". If a positive number is given it is used as
+               number of pixel from left/top. If a negative number is given it
+               is used as number of pixel from right/bottom. You can also
+               specify 'm' for centering the image.
+
+               Example:
+               setenv splashpos m,m
+                       => image at center of screen
+
+               setenv splashpos 30,20
+                       => image at x = 30 and y = 20
+
+               setenv splashpos -10,m
+                       => vertically centered image
+                          at x = dspWidth - bmpWidth - 9
+
 - Gzip compressed BMP image support: CONFIG_VIDEO_BMP_GZIP
 
                If this option is set, additionally to standard BMP
@@ -1165,6 +1188,11 @@ The following options need to be configured:
                Defines a default value for the IP address of a TFTP
                server to contact when using the "tftboot" command.
 
+               CONFIG_KEEP_SERVERADDR
+
+               Keeps the server's MAC address, in the env 'serveraddr'
+               for passing to bootargs (like Linux's netconsole option)
+
 - Multicast TFTP Mode:
                CONFIG_MCAST_TFTP