spi: Migrate CONFIG_MXC_SPI to Kconfig

[u-boot] / README

diff --git a/README b/README
index b53ea7dfe3f6d8201d75135ffd001e4f7c19a96a..d12cfcae63e4b47b8e1a99b272396b2cc198a809 100644 (file)
--- a/README
+++ b/README
@@ -2001,11 +2001,6 @@ The following options need to be configured:
                SPI EEPROM, also an instance works with Crystal A/D and
                D/As on the SACSng board)
 
-               CONFIG_SH_SPI
-
-               Enables the driver for SPI controller on SuperH. Currently
-               only SH7757 is supported.
-
                CONFIG_SOFT_SPI
 
                Enables a software (bit-bang) SPI driver rather than
@@ -2024,11 +2019,6 @@ The following options need to be configured:
                Currently supported on some MPC8xxx processors.  For an
                example, see include/configs/mpc8349emds.h.
 
-               CONFIG_MXC_SPI
-
-               Enables the driver for the SPI controllers on i.MX and MXC
-               SoCs. Currently i.MX31/35/51 are supported.
-
                CONFIG_SYS_SPI_MXC_WAIT
                Timeout for waiting until spi transfer completed.
                default: (CONFIG_SYS_HZ/100)     /* 10 ms */
@@ -2311,18 +2301,6 @@ The following options need to be configured:
                CONFIG_SF_DEFAULT_MODE          (see include/spi.h)
                CONFIG_SF_DEFAULT_SPEED         in Hz
 
-               CONFIG_SYSTEMACE
-
-               Adding this option adds support for Xilinx SystemACE
-               chips attached via some sort of local bus. The address
-               of the chip must also be defined in the
-               CONFIG_SYS_SYSTEMACE_BASE macro. For example:
-
-               #define CONFIG_SYSTEMACE
-               #define CONFIG_SYS_SYSTEMACE_BASE 0xf0000000
-
-               When SystemACE support is added, the "ace" device type
-               becomes available to the fat commands, i.e. fatls.
 
 - TFTP Fixed UDP Port:
                CONFIG_TFTP_PORT
@@ -3719,6 +3697,11 @@ this behavior and build U-Boot to some external directory:
 Note that the command line "O=" setting overrides the KBUILD_OUTPUT environment
 variable.
 
+User specific CPPFLAGS, AFLAGS and CFLAGS can be passed to the compiler by
+setting the according environment variables KCPPFLAGS, KAFLAGS and KCFLAGS.
+For example to treat all compiler warnings as errors:
+
+       make KCFLAGS=-Werror
 
 Please be aware that the Makefiles assume you are using GNU make, so
 for instance on NetBSD you might need to use "gmake" instead of