if ARCH_ZYNQMP
+config SPL_FAT_SUPPORT
+ default y
+
+config SPL_LIBCOMMON_SUPPORT
+ default y
+
+config SPL_LIBDISK_SUPPORT
+ default y
+
+config SPL_LIBGENERIC_SUPPORT
+ default y
+
+config SPL_MMC_SUPPORT
+ default y
+
+config SPL_SERIAL_SUPPORT
+ default y
+
+config SPL_SPI_FLASH_SUPPORT
+ default y if ZYNQ_QSPI
+
+config SPL_SPI_SUPPORT
+ default y if ZYNQ_QSPI
+
config SYS_BOARD
default "zynqmp"
Based on this option include/configs/<CONFIG_SYS_CONFIG_NAME>.h header
will be used for board configuration.
+config BOOT_INIT_FILE
+ string "boot.bin init register filename"
+ depends on SPL
+ default ""
+ help
+ Add register writes to boot.bin format (max 256 pairs).
+ Expect a table of register-value pairs, e.g. "0x12345678 0x4321"
+
config ZYNQMP_USB
bool "Configure ZynqMP USB"
config SYS_MALLOC_F_LEN
default 0x600
+config SPL_ZYNQMP_ALT_BOOTMODE_ENABLED
+ bool "Overwrite SPL bootmode"
+ depends on SPL
+ help
+ Overwrite bootmode selected via boot mode pins to tell SPL what should
+ be the next boot device.
+
+config SPL_ZYNQMP_ALT_BOOTMODE
+ hex
+ default 0x0 if JTAG_MODE
+ default 0x1 if QSPI_MODE_24BIT
+ default 0x2 if QSPI_MODE_32BIT
+ default 0x3 if SD_MODE
+ default 0x4 if NAND_MODE
+ default 0x5 if SD_MODE1
+ default 0x6 if EMMC_MODE
+ default 0x7 if USB_MODE
+ default 0xa if SW_USBHOST_MODE
+ default 0xb if SW_SATA_MODE
+
+choice
+ prompt "Boot mode"
+ depends on SPL_ZYNQMP_ALT_BOOTMODE_ENABLED
+ default JTAG
+
+config JTAG_MODE
+ bool "JTAG_MODE"
+
+config QSPI_MODE_24BIT
+ bool "QSPI_MODE_24BIT"
+
+config QSPI_MODE_32BIT
+ bool "QSPI_MODE_32BIT"
+
+config SD_MODE
+ bool "SD_MODE"
+
+config SD_MODE1
+ bool "SD_MODE1"
+
+config NAND_MODE
+ bool "NAND_MODE"
+
+config EMMC_MODE
+ bool "EMMC_MODE"
+
+config USB_MODE
+ bool "USB"
+
+config SW_USBHOST_MODE
+ bool "SW USBHOST_MODE"
+
+config SW_SATA_MODE
+ bool "SW SATA_MODE"
+
+endchoice
endif