regulator-max-microvolt = <3300000>;
};
+ evm_3v3_sd: fixedregulator-sd {
+ compatible = "regulator-fixed";
+ regulator-name = "evm_3v3_sd";
+ regulator-min-microvolt = <3300000>;
+ regulator-max-microvolt = <3300000>;
+ enable-active-high;
+ gpio = <&pcf_gpio_21 5 GPIO_ACTIVE_HIGH>;
+ };
+
extcon_usb1: extcon_usb1 {
compatible = "linux,extcon-usb-gpio";
id-gpio = <&pcf_gpio_21 1 GPIO_ACTIVE_HIGH>;
interrupts = <11 IRQ_TYPE_EDGE_FALLING>;
interrupt-controller;
#interrupt-cells = <2>;
+ u-boot,i2c-offset-len = <0>;
};
};
* VIN6_SEL_S0 is low, thus selecting McASP3 over VIN6
*/
lines-initial-states = <0x0f2b>;
+ u-boot,i2c-offset-len = <0>;
};
};
pinctrl-names = "default";
pinctrl-0 = <&mmc1_pins_default>;
- vmmc-supply = <&ldo1_reg>;
+ vmmc_aux-supply = <&ldo1_reg>;
+ vmmc-supply = <&evm_3v3_sd>;
bus-width = <4>;
/*
* SDCD signal is not being used here - using the fact that GPIO mode
pinctrl-names = "default", "sleep";
pinctrl-0 = <&cpsw_default>;
pinctrl-1 = <&cpsw_sleep>;
+ mode-gpios = <&pcf_gpio_21 4 GPIO_ACTIVE_HIGH>;
};
-&cpsw_emac1 {
+&cpsw_emac0 {
phy_id = <&davinci_mdio>, <3>;
phy-mode = "rgmii";
};
pinctrl-names = "default", "sleep";
pinctrl-0 = <&davinci_mdio_default>;
pinctrl-1 = <&davinci_mdio_sleep>;
- active_slave = <1>;
};
&dcan1 {
pinctrl-names = "default";
pinctrl-0 = <&qspi1_pins>;
- spi-max-frequency = <48000000>;
+ spi-max-frequency = <76800000>;
m25p80@0 {
compatible = "s25fl256s1","spi-flash";
- spi-max-frequency = <48000000>;
+ spi-max-frequency = <64000000>;
reg = <0>;
spi-tx-bus-width = <1>;
spi-rx-bus-width = <4>;
- spi-cpol;
- spi-cpha;
#address-cells = <1>;
#size-cells = <1>;