*/
/dts-v1/;
-/include/ "exynos54xx.dtsi"
+#include "exynos54xx.dtsi"
/ {
model = "Samsung/Google Peach Pit board based on Exynos5420";
"google,peach", "samsung,exynos5420", "samsung,exynos5";
config {
- google,bad-wake-gpios = <&gpio 0x56 0>; /* gpx0-6 */
+ google,bad-wake-gpios = <&gpx0 6 GPIO_ACTIVE_HIGH>;
hwid = "PIT TEST A-A 7848";
lazy-init = <1>;
};
aliases {
serial0 = "/serial@12C30000";
console = "/serial@12C30000";
- pmic = "/i2c@12ca0000";
+ pmic = "/i2c@12CA0000";
+ i2c104 = &i2c_tunnel;
};
dmc {
mem-manuf = "samsung";
mem-type = "ddr3";
clock-frequency = <800000000>;
- arm-frequency = <1700000000>;
+ arm-frequency = <900000000>;
};
tmu@10060000 {
};
/* MAX77802 is on i2c bus 4 */
- i2c@12ca0000 {
+ i2c@12CA0000 {
clock-frequency = <400000>;
power-regulator@9 {
compatible = "maxim,max77802-pmic";
};
};
- i2c@12cd0000 { /* i2c7 */
+ i2c@12CD0000 { /* i2c7 */
clock-frequency = <100000>;
soundcodec@20 {
reg = <0x20>;
compatible = "maxim,max98090-codec";
};
+
+ edp-lvds-bridge@48 {
+ compatible = "parade,ps8625";
+ reg = <0x48>;
+ sleep-gpio = <&gpx3 5 GPIO_ACTIVE_HIGH>;
+ reset-gpio = <&gpy7 7 GPIO_ACTIVE_HIGH>;
+ };
};
sound@3830000 {
samsung,codec-type = "max98090";
};
- i2c@12e10000 { /* i2c9 */
+ i2c@12E10000 { /* i2c9 */
clock-frequency = <400000>;
tpm@20 {
- compatible = "infineon,slb9645-tpm";
+ compatible = "infineon,slb9645tt";
reg = <0x20>;
};
};
spi@12d30000 { /* spi1 */
spi-max-frequency = <50000000>;
firmware_storage_spi: flash@0 {
+ compatible = "spi-flash";
reg = <0>;
/*
};
};
- spi@12d40000 { /* spi2 */
- spi-max-frequency = <4000000>;
- spi-deactivate-delay = <200>;
- cros-ec@0 {
- reg = <0>;
- compatible = "google,cros-ec";
- spi-half-duplex;
- spi-max-timeout-ms = <1100>;
- spi-frame-header = <0xec>;
- ec-interrupt = <&gpio 93 1>; /* GPX1_5 */
+ xhci@12000000 {
+ samsung,vbus-gpio = <&gph0 0 GPIO_ACTIVE_HIGH>;
+ };
- /*
- * This describes the flash memory within the EC. Note
- * that the STM32L flash erases to 0, not 0xff.
- */
- #address-cells = <1>;
- #size-cells = <1>;
- flash@8000000 {
- reg = <0x08000000 0x20000>;
- erase-value = <0>;
- };
- };
+ xhci@12400000 {
+ samsung,vbus-gpio = <&gph0 1 GPIO_ACTIVE_HIGH>;
};
- xhci@12000000 {
- samsung,vbus-gpio = <&gpio 0x40 0>; /* H00 */
+ fimd@14400000 {
+ samsung,vl-freq = <60>;
+ samsung,vl-col = <1366>;
+ samsung,vl-row = <768>;
+ samsung,vl-width = <1366>;
+ samsung,vl-height = <768>;
+
+ samsung,vl-clkp;
+ samsung,vl-dp;
+ samsung,vl-bpix = <4>;
+
+ samsung,vl-hspw = <32>;
+ samsung,vl-hbpd = <40>;
+ samsung,vl-hfpd = <40>;
+ samsung,vl-vspw = <6>;
+ samsung,vl-vbpd = <10>;
+ samsung,vl-vfpd = <12>;
+ samsung,vl-cmd-allow-len = <0xf>;
+
+ samsung,winid = <3>;
+ samsung,interface-mode = <1>;
+ samsung,dp-enabled = <1>;
+ samsung,dual-lcd-enabled = <0>;
};
+};
- xhci@12400000 {
- samsung,vbus-gpio = <&gpio 0x41 0>; /* H01 */
+&spi_2 {
+ spi-max-frequency = <3125000>;
+ spi-deactivate-delay = <200>;
+ status = "okay";
+ num-cs = <1>;
+ samsung,spi-src-clk = <0>;
+ cs-gpios = <&gpb1 2 0>;
+
+ cros_ec: cros-ec@0 {
+ compatible = "google,cros-ec-spi";
+ interrupt-parent = <&gpx1>;
+ interrupts = <5 0>;
+ reg = <0>;
+ spi-half-duplex;
+ spi-max-timeout-ms = <1100>;
+ ec-interrupt = <&gpx1 5 GPIO_ACTIVE_LOW>;
+ #address-cells = <1>;
+ #size-cells = <1>;
+
+ /*
+ * This describes the flash memory within the EC. Note
+ * that the STM32L flash erases to 0, not 0xff.
+ */
+ flash@8000000 {
+ reg = <0x08000000 0x20000>;
+ erase-value = <0>;
+ };
+
+ controller-data {
+ samsung,spi-feedback-delay = <1>;
+ };
+
+ i2c_tunnel: i2c-tunnel {
+ compatible = "google,cros-ec-i2c-tunnel";
+ #address-cells = <1>;
+ #size-cells = <0>;
+ google,remote-bus = <0>;
+
+ battery: sbs-battery@b {
+ compatible = "sbs,sbs-battery";
+ reg = <0xb>;
+ sbs,poll-retry-count = <1>;
+ sbs,i2c-retry-count = <2>;
+ };
+
+ power-regulator@48 {
+ compatible = "ti,tps65090";
+ reg = <0x48>;
+
+ regulators {
+ tps65090_dcdc1: dcdc1 {
+ ti,enable-ext-control;
+ };
+ tps65090_dcdc2: dcdc2 {
+ ti,enable-ext-control;
+ };
+ tps65090_dcdc3: dcdc3 {
+ ti,enable-ext-control;
+ };
+ tps65090_fet1: fet1 {
+ regulator-name = "vcd_led";
+ };
+ tps65090_fet2: fet2 {
+ regulator-name = "video_mid";
+ regulator-always-on;
+ };
+ tps65090_fet3: fet3 {
+ regulator-name = "wwan_r";
+ regulator-always-on;
+ };
+ tps65090_fet4: fet4 {
+ regulator-name = "sdcard";
+ regulator-always-on;
+ };
+ tps65090_fet5: fet5 {
+ regulator-name = "camout";
+ regulator-always-on;
+ };
+ tps65090_fet6: fet6 {
+ regulator-name = "lcd_vdd";
+ };
+ tps65090_fet7: fet7 {
+ regulator-name = "video_mid_1a";
+ regulator-always-on;
+ };
+ tps65090_ldo1: ldo1 {
+ };
+ tps65090_ldo2: ldo2 {
+ };
+ };
+
+ charger {
+ compatible = "ti,tps65090-charger";
+ };
+ };
+ };
};
};
+
+#include "cros-ec-keyboard.dtsi"
projects / u-boot / blobdiff