* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
* GNU General Public License for more details.
*
- * You should have received a copy of the GNU General Public
- * License along with this file; if not, write to the Free
- * Software Foundation, Inc., 51 Franklin St, Fifth Floor, Boston,
- * MA 02110-1301 USA
- *
* Or, alternatively,
*
* b) Permission is hereby granted, free of charge, to any person
leds {
compatible = "gpio-leds";
pinctrl-names = "default";
- pinctrl-0 = <&led_pins_optimus>;
+ pinctrl-0 = <&led_pins_optimus>, <&led_r_pins_optimus>;
/* The LED names match those found on the board */
gpios = <&pio 7 1 GPIO_ACTIVE_HIGH>;
};
- /* led3 is on PM15, in R_PIO */
+ led3 {
+ label = "optimus:led3:usr";
+ gpios = <&r_pio 1 15 GPIO_ACTIVE_HIGH>; /* PM15 */
+ };
led4 {
label = "optimus:led4:usr";
status = "okay";
};
-&i2c3 {
- pinctrl-names = "default";
- pinctrl-0 = <&i2c3_pins_a>;
- status = "okay";
-};
-
-&i2c3_pins_a {
- /* Enable internal pull-up */
- allwinner,pull = <SUN4I_PINCTRL_PULL_UP>;
-};
-
&ohci0 {
status = "okay";
};
vmmc-supply = <®_vcc3v0>;
bus-width = <8>;
non-removable;
+ cap-mmc-hw-reset;
status = "okay";
};
+&mmc2_8bit_pins {
+ /* Increase drive strength for DDR modes */
+ allwinner,drive = <SUN4I_PINCTRL_40_MA>;
+};
+
®_usb1_vbus {
pinctrl-0 = <&usb1_vbus_pin_optimus>;
gpio = <&pio 7 4 GPIO_ACTIVE_HIGH>; /* PH4 */
status = "okay";
};
-&uart0 {
- pinctrl-names = "default";
- pinctrl-0 = <&uart0_pins_a>;
+&r_ir {
status = "okay";
};
-&uart4 {
- pinctrl-names = "default";
- pinctrl-0 = <&uart4_pins_a>;
+&r_pio {
+ led_r_pins_optimus: led-pins@1 {
+ allwinner,pins = "PM15";
+ allwinner,function = "gpio_out";
+ allwinner,drive = <SUN4I_PINCTRL_10_MA>;
+ allwinner,pull = <SUN4I_PINCTRL_NO_PULL>;
+ };
+};
+
+&r_rsb {
status = "okay";
};
-&uart4_pins_a {
- /* Enable internal pull-up */
- allwinner,pull = <SUN4I_PINCTRL_PULL_UP>;
+&uart0 {
+ pinctrl-names = "default";
+ pinctrl-0 = <&uart0_pins_a>;
+ status = "okay";
};
&usbphy1 {