ulong reg;
#endif
+ bootstage_mark_name(BOOTSTAGE_ID_START_UBOOT_F, "board_init_f");
+
/* Pointer is writable since we allocated a register for it */
gd = (gd_t *) ((CONFIG_SYS_INIT_SP_ADDR) & ~0x07);
/* compiler optimization barrier needed for GCC >= 3.4 */
}
}
+#ifdef CONFIG_OF_CONTROL
+ /* For now, put this check after the console is ready */
+ if (fdtdec_prepare_fdt()) {
+ panic("** CONFIG_OF_CONTROL defined but no FDT - please see "
+ "doc/README.fdt-control");
+ }
+#endif
+
debug("monitor len: %08lX\n", gd->mon_len);
/*
* Ram is setup, size stored in gd !!
gd = id;
gd->flags |= GD_FLG_RELOC; /* tell others: relocation done */
+ bootstage_mark_name(BOOTSTAGE_ID_START_UBOOT_R, "board_init_r");
monitor_flash_len = _end_ofs;
debug("monitor flash len: %08lX\n", monitor_flash_len);
board_init(); /* Setup chipselects */
-
+ /*
+ * TODO: printing of the clock inforamtion of the board is now
+ * implemented as part of bdinfo command. Currently only support for
+ * davinci SOC's is added. Remove this check once all the board
+ * implement this.
+ */
+#ifdef CONFIG_CLOCKS
+ set_cpu_clk_info(); /* Setup clock information */
+#endif
#ifdef CONFIG_SERIAL_MULTI
serial_initialize();
#endif
arm_pci_init();
#endif
- /* IP Address */
- gd->bd->bi_ip_addr = getenv_IPaddr("ipaddr");
-
stdio_init(); /* get the devices list going. */
jumptable_init();
/* Initialize from environment */
load_addr = getenv_ulong("loadaddr", 16, load_addr);
-#if defined(CONFIG_CMD_NET)
- {
- char *s = getenv("bootfile");
-
- if (s != NULL)
- copy_filename(BootFile, s, sizeof(BootFile));
- }
-#endif
#ifdef CONFIG_BOARD_LATE_INIT
board_late_init();