config IDENT_STRING
default " Allwinner Technology"
+config SUN6I_P2WI
+ bool "Allwinner sun6i internal P2WI controller"
+ help
+ If you say yes to this option, support will be included for the
+ P2WI (Push/Pull 2 Wire Interface) controller embedded in some sunxi
+ SOCs.
+ The P2WI looks like an SMBus controller (which supports only byte
+ accesses), except that it only supports one slave device.
+ This interface is used to connect to specific PMIC devices (like the
+ AXP221).
+
+config SUN6I_PRCM
+ bool
+ help
+ Support for the PRCM (Power/Reset/Clock Management) unit available
+ in A31 SoC.
+
config SUNXI_HIGH_SRAM
bool
default n
select ARM_CORTEX_CPU_IS_UP
select SUNXI_GEN_SUN4I
select SUPPORT_SPL
+ imply CONS_INDEX_2 if !DM_SERIAL
config MACH_SUN6I
bool "sun6i (Allwinner A31)"
select CPU_V7_HAS_NONSEC
select CPU_V7_HAS_VIRT
select ARCH_SUPPORT_PSCI
+ select SUN6I_P2WI
+ select SUN6I_PRCM
select SUNXI_GEN_SUN6I
select SUPPORT_SPL
select ARMV7_BOOT_SEC_DEFAULT if OLD_SUNXI_KERNEL_COMPAT
select SUNXI_GEN_SUN6I
select SUPPORT_SPL
select ARMV7_BOOT_SEC_DEFAULT if OLD_SUNXI_KERNEL_COMPAT
+ imply CONS_INDEX_5 if !DM_SERIAL
config MACH_SUN8I_A33
bool "sun8i (Allwinner A33)"
select SUNXI_GEN_SUN6I
select SUPPORT_SPL
select ARMV7_BOOT_SEC_DEFAULT if OLD_SUNXI_KERNEL_COMPAT
+ imply CONS_INDEX_5 if !DM_SERIAL
config MACH_SUN8I_A83T
bool "sun8i (Allwinner A83T)"
default 0x2fe00000 if MACH_SUN9I
default 0x4fe00000 if MACH_SUN50I
+config SPL_SPI_SUNXI
+ bool "Support for SPI Flash on Allwinner SoCs in SPL"
+ depends on MACH_SUN4I || MACH_SUN5I || MACH_SUN7I || MACH_SUNXI_H3_H5 || MACH_SUN50I
+ help
+ Enable support for SPI Flash. This option allows SPL to read from
+ sunxi SPI Flash. It uses the same method as the boot ROM, so does
+ not need any extra configuration.
+
endif