ARM: rmobile: Add R8A77995 SoC

[u-boot] / arch / arm / mach-tegra / Kconfig

diff --git a/arch/arm/mach-tegra/Kconfig b/arch/arm/mach-tegra/Kconfig
index 316feba29d60c3b19b19d0a6f0985480c1338f26..51e50907d27a25177ebc9e6bbbcd9306e0a346c0 100644 (file)
--- a/arch/arm/mach-tegra/Kconfig
+++ b/arch/arm/mach-tegra/Kconfig
@@ -29,8 +29,6 @@ config TEGRA_COMMON
        select DM_I2C
        select DM_KEYBOARD
        select DM_MMC
-       select DM_PCI
-       select DM_PCI_COMPAT
        select DM_PWM
        select DM_RESET
        select DM_SERIAL
@@ -39,6 +37,8 @@ config TEGRA_COMMON
        select MISC
        select OF_CONTROL
        select VIDCONSOLE_AS_LCD if DM_VIDEO
+       select BOARD_EARLY_INIT_F
+       imply CRC32_VERIFY
 
 config TEGRA_NO_BPMP
        bool "Tegra common options for SoCs without BPMP"
@@ -50,6 +50,7 @@ config TEGRA_ARMV7_COMMON
        bool "Tegra 32-bit common options"
        select CPU_V7
        select SPL
+       select SPL_BOARD_INIT if SPL
        select SUPPORT_SPL
        select TEGRA_COMMON
        select TEGRA_GPIO
@@ -66,10 +67,15 @@ choice
 
 config TEGRA20
        bool "Tegra20 family"
+       select ARM_ERRATA_716044
+       select ARM_ERRATA_742230
+       select ARM_ERRATA_751472
        select TEGRA_ARMV7_COMMON
 
 config TEGRA30
        bool "Tegra30 family"
+       select ARM_ERRATA_743622
+       select ARM_ERRATA_751472
        select TEGRA_ARMV7_COMMON
 
 config TEGRA114
@@ -79,6 +85,8 @@ config TEGRA114
 config TEGRA124
        bool "Tegra124 family"
        select TEGRA_ARMV7_COMMON
+       imply REGMAP
+       imply SYSCON
 
 config TEGRA210
        bool "Tegra210 family"
@@ -122,4 +130,20 @@ source "arch/arm/mach-tegra/tegra124/Kconfig"
 source "arch/arm/mach-tegra/tegra210/Kconfig"
 source "arch/arm/mach-tegra/tegra186/Kconfig"
 
+config CMD_ENTERRCM
+       bool "Enable 'enterrcm' command"
+       default y
+       help
+         Tegra's boot ROM supports a mode whereby code may be downloaded and
+         flash-programmed over a USB connection. On dev boards, this is
+         typically entered by holding down a "force recovery" button and
+         resetting the CPU. However, not all boards have such a button (one
+         example is the Compulab Trimslice), so a method to enter RCM from
+         software is useful.
+
+         Even on boards other than Trimslice, controlling this over a UART
+         may be useful, e.g. to allow simple remote control without the need
+         for mechanical button actuators, or hooking up relays/... to the
+         button.
+
 endif