#include <asm/mach-common/bits/core.h>
#include <asm/mach-common/bits/ebiu.h>
#include <asm/mach-common/bits/trace.h>
+#include <asm/serial.h>
#include "cpu.h"
-#include "serial.h"
#include "initcode.h"
ulong bfin_poweron_retx;
+#if defined(CONFIG_CORE1_RUN) && defined(COREB_L1_CODE_START)
+void bfin_core1_start(void)
+{
+#ifdef BF561_FAMILY
+ /* Enable core 1 */
+ bfin_write_SYSCR(bfin_read_SYSCR() & ~0x0020);
+#else
+ /* Enable core 1 */
+ bfin_write32(RCU0_SVECT1, COREB_L1_CODE_START);
+ bfin_write32(RCU0_CRCTL, 0);
+
+ bfin_write32(RCU0_CRCTL, 0x2);
+
+ /* Check if core 1 starts */
+ while (!(bfin_read32(RCU0_CRSTAT) & 0x2))
+ continue;
+
+ bfin_write32(RCU0_CRCTL, 0);
+
+ /* flag to notify cces core 1 application */
+ bfin_write32(SDU0_MSG_SET, (1 << 19));
+#endif
+}
+#endif
+
__attribute__ ((__noreturn__))
void cpu_init_f(ulong bootflag, ulong loaded_from_ldr)
{
/* Reset upon a double exception rather than just hanging.
* Do not do bfin_read on SWRST as that will reset status bits.
*/
+# ifdef SWRST
bfin_write_SWRST(DOUBLE_FAULT);
+# endif
+#endif
+
+#if defined(CONFIG_CORE1_RUN) && defined(COREB_L1_CODE_START)
+ bfin_core1_start();
#endif
serial_early_puts("Board init flash\n");
board_init_f(bootflag);
+
+ /* should not be reached */
+ while (1);
}
int exception_init(void)
#elif defined(SICA_IMASK0)
bfin_write_SICA_IMASK0(0);
bfin_write_SICA_IMASK1(0);
-#else
+#elif defined(SIC_IMASK)
bfin_write_SIC_IMASK(0);
#endif
/* Set up a dummy NMI handler if needed. */