#define SDRAM_CFG0 0x20 /* memory controller options 0 */
#define SDRAM_CFG1 0x21 /* memory controller options 1 */
+#define SDRAM0_BESR0 0x0000 /* bus error status reg 0 */
+#define SDRAM0_BESR1 0x0008 /* bus error status reg 1 */
#define SDRAM0_BEAR 0x0010 /* bus error address reg */
#define SDRAM0_SLIO 0x0018 /* ddr sdram slave interface options */
#define SDRAM0_CFG0 0x0020 /* ddr sdram options 0 */
*/
#if defined(CONFIG_440SPE) || \
defined(CONFIG_460EX) || defined(CONFIG_460GT) || \
- defined(CONFIG_460SX)
+ defined(CONFIG_460SX) || defined(CONFIG_APM821XX)
#define SDRAM_RXBAS_SDBA_MASK 0xFFE00000 /* Base address */
#define SDRAM_RXBAS_SDBA_ENCODE(n) ((u32)(((phys_size_t)(n) >> 2) & 0xFFE00000))
#define SDRAM_RXBAS_SDBA_DECODE(n) ((((phys_size_t)(n)) & 0xFFE00000) << 2)
/*
* Memory controller registers
*/
+#if defined(CONFIG_405EX) || defined(CONFIG_APM821XX)
#define SDRAM_BESR 0x00 /* PLB bus error status (read/clear) */
#define SDRAM_BESRT 0x01 /* PLB bus error status (test/set) */
#define SDRAM_BEARL 0x02 /* PLB bus error address low */
#define SDRAM_WMIRQT 0x07 /* PLB write master interrupt (test/set) */
#define SDRAM_PLBOPT 0x08 /* PLB slave options */
#define SDRAM_PUABA 0x09 /* PLB upper address base */
-#ifndef CONFIG_405EX
-#define SDRAM_MCSTAT 0x14 /* memory controller status */
-#else
#define SDRAM_MCSTAT 0x1F /* memory controller status */
-#endif
+#else /* CONFIG_405EX || CONFIG_APM821XX */
+#define SDRAM_MCSTAT 0x14 /* memory controller status */
+#endif /* CONFIG_405EX || CONFIG_APM821XX */
#define SDRAM_MCOPT1 0x20 /* memory controller options 1 */
#define SDRAM_MCOPT2 0x21 /* memory controller options 2 */
#define SDRAM_MODT0 0x22 /* on die termination for bank 0 */
#define SDRAM_MEMODE 0x89 /* memory extended mode */
#define SDRAM_ECCES 0x98 /* ECC error status */
#define SDRAM_CID 0xA4 /* core ID */
-#ifndef CONFIG_405EX
+#if !defined(CONFIG_405EX) && !defined(CONFIG_APM821XX)
#define SDRAM_RID 0xA8 /* revision ID */
#endif
#define SDRAM_FCSR 0xB0 /* feedback calibration status */
#define SDRAM_RTSR 0xB1 /* run time status tracking */
-#ifdef CONFIG_405EX
+#if defined(CONFIG_405EX) || defined(CONFIG_APM821XX)
#define SDRAM_RID 0xF8 /* revision ID */
#endif
#define SDRAM_RTSR_TRK1SM_ATPLS1 0x80000000 /* atpls1 state */
#define SDRAM_RTSR_TRK1SM_RESET 0xC0000000 /* reset state */
-#define SDR0_MFR_FIXD 0x10000000 /* Workaround for PCI/DMA */
-
#endif /* CONFIG_SDRAM_PPC4xx_IBM_DDR2 */
#if defined(CONFIG_SDRAM_PPC4xx_DENALI_DDR2)