MAINTAINERS: board: qcom: db410c, db820c: update email.

[u-boot] / arch / x86 / cpu / ivybridge / cpu.c

diff --git a/arch/x86/cpu/ivybridge/cpu.c b/arch/x86/cpu/ivybridge/cpu.c
index 85e361a58f07a72ba70842aa5f24622f0dce4255..099cb94e5d280969afdbae977f1250724e81d6ce 100644 (file)
--- a/arch/x86/cpu/ivybridge/cpu.c
+++ b/arch/x86/cpu/ivybridge/cpu.c
@@ -74,7 +74,7 @@ int arch_cpu_init_dm(void)
        /*
         * We should do as little as possible before the serial console is
         * up. Perhaps this should move to later. Our next lot of init
-        * happens in print_cpuinfo() when we have a console
+        * happens in checkcpu() when we have a console
         */
        ret = set_flex_ratio_to_tdp_nominal();
        if (ret)
@@ -125,12 +125,10 @@ static void enable_usb_bar(struct udevice *bus)
        pci_bus_write_config(bus, usb3, PCI_COMMAND, cmd, PCI_SIZE_32);
 }
 
-int print_cpuinfo(void)
+int checkcpu(void)
 {
        enum pei_boot_mode_t boot_mode = PEI_BOOT_NONE;
-       char processor_name[CPU_MAX_NAME_LEN];
        struct udevice *dev, *lpc;
-       const char *name;
        uint32_t pm1_cnt;
        uint16_t pm1_sts;
        int ret;
@@ -169,8 +167,10 @@ int print_cpuinfo(void)
 
        /* Enable SPD ROMs and DDR-III DRAM */
        ret = uclass_first_device_err(UCLASS_I2C, &dev);
-       if (ret)
+       if (ret) {
+               debug("%s: Failed to get I2C (ret=%d)\n", __func__, ret);
                return ret;
+       }
 
        /* Prepare USB controller early in S3 resume */
        if (boot_mode == PEI_BOOT_RESUME) {
@@ -180,6 +180,14 @@ int print_cpuinfo(void)
 
        gd->arch.pei_boot_mode = boot_mode;
 
+       return 0;
+}
+
+int print_cpuinfo(void)
+{
+       char processor_name[CPU_MAX_NAME_LEN];
+       const char *name;
+
        /* Print processor name */
        name = cpu_get_name(processor_name);
        printf("CPU:   %s\n", name);