bool
select HAVE_FSP
select HAVE_CMC
+ select ARCH_EARLY_INIT_R
if INTEL_QUEENSBAY
-config HAVE_FSP
- bool "Add an Firmware Support Package binary"
- help
- Select this option to add an Firmware Support Package binary to
- the resulting U-Boot image. It is a binary blob which U-Boot uses
- to set up SDRAM and other chipset specific initialization.
-
- Note: Without this binary U-Boot will not be able to set up its
- SDRAM so will not boot.
-
-config FSP_FILE
- string "Firmware Support Package binary filename"
- depends on HAVE_FSP
- default "fsp.bin"
- help
- The filename of the file to use as Firmware Support Package binary
- in the board directory.
-
-config FSP_ADDR
- hex "Firmware Support Package binary location"
- depends on HAVE_FSP
- default 0xfffc0000
- help
- FSP is not Position Independent Code (PIC) and the whole FSP has to
- be rebased if it is placed at a location which is different from the
- perferred base address specified during the FSP build. Use Intel's
- Binary Configuration Tool (BCT) to do the rebase.
-
- The default base address of 0xfffc0000 indicates that the binary must
- be located at offset 0xc0000 from the beginning of a 1MB flash device.
-
-config FSP_TEMP_RAM_ADDR
- hex
- default 0x2000000
- help
- Stack top address which is used in FspInit after DRAM is ready and
- CAR is disabled.
-
config HAVE_CMC
bool "Add a Chipset Micro Code state machine binary"
help
The default base address of 0xfffb0000 indicates that the binary must
be located at offset 0xb0000 from the beginning of a 1MB flash device.
+config CPU_ADDR_BITS
+ int
+ default 32
+
+config DISABLE_IGD
+ bool "Disable Integrated Graphics Device (IGD)"
+ help
+ Disable the Integrated Graphics Device (IGD) so that it does not
+ show in the PCI configuration space as a VGA disaplay controller.
+ This gives a chance for U-Boot to run PCI/PCIe based graphics
+ card's VGA BIOS and use that card for the graphics console.
+
endif