smdk5420: Remove GPIO enums

[u-boot] / board / BuR / tseries / board.c

diff --git a/board/BuR/tseries/board.c b/board/BuR/tseries/board.c
index 66747eb5d3518cbe83b6bfde38f25054465b9d75..89e989f2467411341f34d3f437ee5f3d595f319a 100644 (file)
--- a/board/BuR/tseries/board.c
+++ b/board/BuR/tseries/board.c
@@ -28,15 +28,14 @@
 #include <power/tps65217.h>
 #include "../common/bur_common.h"
 #include <lcd.h>
+#include <watchdog.h>
 
 DECLARE_GLOBAL_DATA_PTR;
 
 /* --------------------------------------------------------------------------*/
 /* -- defines for GPIO -- */
-#define        ETHLED_ORANGE   (96+16) /* GPIO3_16 */
 #define        REPSWITCH       (0+20)  /* GPIO0_20 */
 
-
 #if defined(CONFIG_SPL_BUILD)
 /* TODO: check ram-timing ! */
 static const struct ddr_data ddr3_data = {
@@ -124,6 +123,10 @@ void am33xx_spl_board_init(void)
        /* setup LCD-Pixel Clock */
        writel(0x2, &cmdpll->clklcdcpixelclk);  /* clock comes from perPLL M2 */
 
+       /* setup I2C */
+       enable_i2c_pin_mux();
+       i2c_set_bus_num(0);
+       i2c_init(CONFIG_SYS_OMAP24_I2C_SPEED, CONFIG_SYS_OMAP24_I2C_SLAVE);
        pmicsetup(0);
 }
 
@@ -144,6 +147,9 @@ void sdram_init(void)
 /* Basic board specific setup.  Pinmux has been handled already. */
 int board_init(void)
 {
+#if defined(CONFIG_HW_WATCHDOG)
+       hw_watchdog_init();
+#endif
        gd->bd->bi_boot_params = CONFIG_SYS_SDRAM_BASE + 0x100;
 #ifdef CONFIG_NAND
        gpmc_init();