arm: marvell: Extract kirkwood gpio functions into new common file gpio.c

[u-boot] / board / Seagate / dockstar / dockstar.c

diff --git a/board/Seagate/dockstar/dockstar.c b/board/Seagate/dockstar/dockstar.c
index dc73dfaa3ab2470271611b178adc5b212f6701bf..838f578104d1310208a7ece50da87e807ee22776 100644 (file)
--- a/board/Seagate/dockstar/dockstar.c
+++ b/board/Seagate/dockstar/dockstar.c
@@ -26,9 +26,9 @@ int board_early_init_f(void)
         * There are maximum 64 gpios controlled through 2 sets of registers
         * the  below configuration configures mainly initial LED status
         */
-       kw_config_gpio(DOCKSTAR_OE_VAL_LOW,
-                       DOCKSTAR_OE_VAL_HIGH,
-                       DOCKSTAR_OE_LOW, DOCKSTAR_OE_HIGH);
+       mvebu_config_gpio(DOCKSTAR_OE_VAL_LOW,
+                         DOCKSTAR_OE_VAL_HIGH,
+                         DOCKSTAR_OE_LOW, DOCKSTAR_OE_HIGH);
 
        /* Multi-Purpose Pins Functionality configuration */
        static const u32 kwmpp_config[] = {
@@ -143,7 +143,7 @@ void reset_phy(void)
 
 static void set_leds(u32 leds, u32 blinking)
 {
-       struct kwgpio_registers *r = (struct kwgpio_registers *)KW_GPIO1_BASE;
+       struct kwgpio_registers *r = (struct kwgpio_registers *)MVEBU_GPIO1_BASE;
        u32 oe = readl(&r->oe) | BOTH_LEDS;
        writel(oe & ~leds, &r->oe);     /* active low */
        u32 bl = readl(&r->blink_en) & ~BOTH_LEDS;