+// SPDX-License-Identifier: GPL-2.0+
/*
* Copyright (C) 2010-2013 Freescale Semiconductor, Inc.
* Copyright (C) 2014, Bachmann electronic GmbH
- *
- * SPDX-License-Identifier: GPL-2.0+
*/
#include <common.h>
#include <asm/arch/iomux.h>
#include <malloc.h>
#include <asm/arch/mx6-pins.h>
-#include <asm/imx-common/iomux-v3.h>
-#include <asm/imx-common/sata.h>
-#include <asm/imx-common/mxc_i2c.h>
-#include <asm/imx-common/boot_mode.h>
+#include <asm/mach-imx/iomux-v3.h>
+#include <asm/mach-imx/sata.h>
+#include <asm/mach-imx/mxc_i2c.h>
+#include <asm/mach-imx/boot_mode.h>
#include <asm/arch/crm_regs.h>
#include <asm/arch/sys_proto.h>
#include <mmc.h>
writel(0x000003FF, &ccm->CCGR6);
}
-static void gpr_init(void)
-{
- struct iomuxc *iomux = (struct iomuxc *)IOMUXC_BASE_ADDR;
-
- /* enable AXI cache for VDOA/VPU/IPU */
- writel(0xF00000CF, &iomux->gpr[4]);
- /* set IPU AXI-id0 Qos=0xf(bypass) AXI-id1 Qos=0x7 */
- writel(0x007F007F, &iomux->gpr[6]);
- writel(0x007F007F, &iomux->gpr[7]);
-}
-
int board_early_init_f(void)
{
ccgr_init();
return 0;
}
-static iomux_v3_cfg_t const pwm_pad[] = {
- MX6_PAD_SD1_CMD__PWM4_OUT | MUX_PAD_CTRL(OUTPUT_40OHM),
-};
-
static void leds_on(void)
{
/* turn on all possible leds connected via GPIO expander */
/* depending on the phy address we can detect our board version */
if (phydev->addr == 0)
- setenv("boardver", "");
+ env_set("boardver", "");
else
- setenv("boardver", "mr");
+ env_set("boardver", "mr");
printf("using phy at %d\n", phydev->addr);
ret = fec_probe(bis, -1, base, bus, phydev);
leds_on();
-#ifdef CONFIG_CMD_SATA
+#ifdef CONFIG_SATA
setup_sata();
#endif