mx53loco: Place machine ID into board config

[u-boot] / board / bf527-ezkit / video.c

diff --git a/board/bf527-ezkit/video.c b/board/bf527-ezkit/video.c
index 87e7658b4df7a2ba460aac6fb83426b5d127fc1f..ca5e9b0454586e090a0e3b7341afc968e7ef1b7c 100644 (file)
--- a/board/bf527-ezkit/video.c
+++ b/board/bf527-ezkit/video.c
@@ -24,7 +24,7 @@
 #define LCD_Y_RES              240     /* Vertical Resolution */
 #define DMA_BUS_SIZE           16
 
-#ifdef CONFIG_MK_BF527_EZKIT_REV_2_1 /* lq035q1 */
+#ifdef CONFIG_BF527_EZKIT_REV_2_1 /* lq035q1 */
 
 #if !defined(CONFIG_LQ035Q1_USE_RGB888_8_BIT_PPI) && \
     !defined(CONFIG_LQ035Q1_USE_RGB565_8_BIT_PPI)
@@ -125,7 +125,7 @@
 #define PPI_PACK_EN            0x80
 #define PPI_POLS_1             0x8000
 
-#ifdef CONFIG_MK_BF527_EZKIT_REV_2_1
+#ifdef CONFIG_BF527_EZKIT_REV_2_1
 static struct spi_slave *slave;
 static int lq035q1_control(unsigned char reg, unsigned short value)
 {
@@ -305,7 +305,7 @@ void EnableTIMER12(void)
 int video_init(void *dst)
 {
 
-#ifdef CONFIG_MK_BF527_EZKIT_REV_2_1
+#ifdef CONFIG_BF527_EZKIT_REV_2_1
        lq035q1_control(LQ035_SHUT_CTL, LQ035_ON);
        lq035q1_control(LQ035_DRIVER_OUTPUT_CTL, (CONFIG_LQ035Q1_LCD_MODE &
                LQ035_DRIVER_OUTPUT_MASK) | LQ035_DRIVER_OUTPUT_DEFAULT);
@@ -318,7 +318,7 @@ int video_init(void *dst)
        Init_PPI();
        EnablePPI();
 
-#ifdef CONFIG_MK_BF527_EZKIT_REV_2_1
+#ifdef CONFIG_BF527_EZKIT_REV_2_1
        EnableTIMER12();
 #else
        /* Frame sync 2 (VS) needs to start at least one PPI clk earlier */
@@ -388,7 +388,7 @@ void video_stop(void)
        DisableDMA();
        DisableTIMER0();
        DisableTIMER1();
-#ifdef CONFIG_MK_BF527_EZKIT_REV_2_1
+#ifdef CONFIG_BF527_EZKIT_REV_2_1
        lq035q1_control(LQ035_SHUT_CTL, LQ035_SHUT);
 #endif
 }