pbl: use "wait" command instead of "flush" command

[u-boot] / board / broadcom / bcm_ep / board.c

diff --git a/board/broadcom/bcm_ep/board.c b/board/broadcom/bcm_ep/board.c
index 6a70a2e3056007a38958e0df03d63e75a6c9879b..c28b203ceaac8555dd16420ff70caf7678fa9f1a 100644 (file)
--- a/board/broadcom/bcm_ep/board.c
+++ b/board/broadcom/bcm_ep/board.c
@@ -7,6 +7,7 @@
 #include <common.h>
 #include <asm/io.h>
 #include <config.h>
+#include <netdev.h>
 #include <asm/system.h>
 #include <asm/iproc-common/armpll.h>
 
@@ -54,7 +55,7 @@ int board_early_init_f(void)
        return status;
 }
 
-#if defined(CONFIG_ARMV7_NONSEC) || defined(CONFIG_ARMV7_VIRT)
+#ifdef CONFIG_ARMV7_NONSEC
 void smp_set_core_boot_addr(unsigned long addr, int corenr)
 {
 }
@@ -67,3 +68,13 @@ void smp_waitloop(unsigned previous_address)
 {
 }
 #endif
+
+#ifdef CONFIG_BCM_SF2_ETH
+int board_eth_init(bd_t *bis)
+{
+       int rc = -1;
+       printf("Registering BCM sf2 eth\n");
+       rc = bcm_sf2_eth_register(bis, 0);
+       return rc;
+}
+#endif