#include <common.h>
#include <libfdt.h>
#include <fdt_support.h>
-#include <ppc440.h>
+#include <asm/ppc440.h>
#include <asm/processor.h>
#include <asm/io.h>
#include <asm/bitops.h>
#include <miiphy.h>
#endif
#include <serial.h>
+#include <asm/4xx_pci.h>
+
#include "fpga.h"
#include "pmc440.h"
*/
mfsdr(SDR0_PINSTP, val);
if (((val & 0xf0000000) >> 29) != 7)
- return &serial1_device;
+ return &eserial2_device;
ulong scratchreg = in_be32((void*)GPIO0_ISR3L);
if (!(scratchreg & 0x80)) {
}
if (scratchreg & 0x01)
- return &serial1_device;
+ return &eserial2_device;
else
- return &serial0_device;
+ return &eserial1_device;
}
int board_early_init_f(void)
* This fix will make the MAL burst disabling patch for the Linux
* EMAC driver obsolete.
*/
- reg = mfdcr(PLB4_ACR) & ~PLB4_ACR_WRP;
- mtdcr(PLB4_ACR, reg);
+ reg = mfdcr(PLB4A0_ACR) & ~PLB4Ax_ACR_WRP_MASK;
+ mtdcr(PLB4A0_ACR, reg);
#ifdef CONFIG_FPGA
pmc440_init_fpga();
#endif /* defined(CONFIG_PCI) && defined(CONFIG_SYS_PCI_TARGET_INIT) */
/*
- * pci_master_init
+ * Override weak default pci_master_init()
*/
#if defined(CONFIG_PCI) && defined(CONFIG_SYS_PCI_MASTER_INIT)
void pci_master_init(struct pci_controller *hose)
{
- unsigned short temp_short;
-
/*
- * Write the PowerPC440 EP PCI Configuration regs.
- * Enable PowerPC440 EP to be a master on the PCI bus (PMM).
- * Enable PowerPC440 EP to act as a PCI memory target (PTM).
+ * Only configure the master in monach mode
*/
- if (is_monarch()) {
- pci_read_config_word(0, PCI_COMMAND, &temp_short);
- pci_write_config_word(0, PCI_COMMAND,
- temp_short | PCI_COMMAND_MASTER |
- PCI_COMMAND_MEMORY);
- }
+ if (is_monarch())
+ __pci_master_init(hose);
}
#endif /* defined(CONFIG_PCI) && defined(CONFIG_SYS_PCI_MASTER_INIT) */
}
#endif /* defined(CONFIG_PCI) */
-#if defined(CONFIG_POST)
-/*
- * Returns 1 if keys pressed to start the power-on long-running tests
- * Called from board_init_f().
- */
-int post_hotkeys_pressed(void)
-{
- return 0; /* No hotkeys supported */
-}
-#endif /* CONFIG_POST */
-
#ifdef CONFIG_RESET_PHY_R
void reset_phy(void)
{