* MA 02111-1307 USA
*/
#include <common.h>
+#include <netdev.h>
#ifdef CONFIG_STATUS_LED
#include <status_led.h>
#endif
#include <twl4030.h>
#include <asm/io.h>
-#include <asm/arch/gpio.h>
+#include <asm/arch/mmc_host_def.h>
+#include <asm/gpio.h>
#include <asm/arch/mem.h>
#include <asm/arch/mux.h>
#include <asm/arch/sys_proto.h>
#include "zoom2.h"
#include "zoom2_serial.h"
+DECLARE_GLOBAL_DATA_PTR;
+
/*
* This the the zoom2, board specific, gpmc configuration for the
* quad uart on the debug board. The more general gpmc configurations
- * are setup at the cpu level in cpu/arm_cortexa8/omap3/mem.c
+ * are setup at the cpu level in arch/arm/cpu/armv7/omap3/mem.c
*
* The details of the setting of the serial gpmc setup are not available.
* The values were provided by another party.
*/
-void enable_gpmc_cs_config(u32 *gpmc_config, struct gpmc_cs *cs, u32 base,
- u32 size);
-
static u32 gpmc_serial_TL16CP754C[GPMC_MAX_REG] = {
0x00011000,
0x001F1F01,
* and they are not commonly used. They are mentioned here
* only for completeness.
*/
- if (!omap_request_gpio(94)) {
+ if (!gpio_request(94, "")) {
unsigned int val;
- omap_set_gpio_direction(94, 1);
- val = omap_get_gpio_datain(94);
- omap_free_gpio(94);
+ gpio_direction_input(94);
+ val = gpio_get_value(94);
+ gpio_free(94);
if (val)
revision = ZOOM2_REVISION_BETA;
*/
int board_init (void)
{
- DECLARE_GLOBAL_DATA_PTR;
u32 *gpmc_config;
gpmc_init (); /* in SRAM or SDRAM, finish GPMC */
{
zoom2_identify();
twl4030_power_init();
- twl4030_led_init();
+ twl4030_led_init(TWL4030_LED_LEDEN_LEDAON | TWL4030_LED_LEDEN_LEDBON);
dieid_num_r();
/*
/* platform specific muxes */
MUX_ZOOM2 ();
}
+
+#ifdef CONFIG_GENERIC_MMC
+int board_mmc_init(bd_t *bis)
+{
+ omap_mmc_init(0);
+ return 0;
+}
+#endif
+
+#ifdef CONFIG_CMD_NET
+int board_eth_init(bd_t *bis)
+{
+ int rc = 0;
+#ifdef CONFIG_LAN91C96
+ rc = lan91c96_initialize(0, CONFIG_LAN91C96_BASE);
+#endif
+ return rc;
+}
+#endif