#endif
#include <twl4030.h>
#include <asm/io.h>
-#include <asm/arch/gpio.h>
+#include <asm/arch/mmc_host_def.h>
+#include <asm/gpio.h>
#include <asm/arch/mem.h>
#include <asm/arch/mux.h>
#include <asm/arch/sys_proto.h>
#include "zoom2.h"
#include "zoom2_serial.h"
+DECLARE_GLOBAL_DATA_PTR;
+
/*
* This the the zoom2, board specific, gpmc configuration for the
* quad uart on the debug board. The more general gpmc configurations
* and they are not commonly used. They are mentioned here
* only for completeness.
*/
- if (!omap_request_gpio(94)) {
+ if (!gpio_request(94, "")) {
unsigned int val;
- omap_set_gpio_direction(94, 1);
- val = omap_get_gpio_datain(94);
- omap_free_gpio(94);
+ gpio_direction_input(94);
+ val = gpio_get_value(94);
if (val)
revision = ZOOM2_REVISION_BETA;
*/
int board_init (void)
{
- DECLARE_GLOBAL_DATA_PTR;
u32 *gpmc_config;
gpmc_init (); /* in SRAM or SDRAM, finish GPMC */
MUX_ZOOM2 ();
}
+#ifdef CONFIG_GENERIC_MMC
+int board_mmc_init(bd_t *bis)
+{
+ return omap_mmc_init(0, 0, 0, -1, -1);
+}
+#endif
+
#ifdef CONFIG_CMD_NET
int board_eth_init(bd_t *bis)
{