* memory.
*
* If at some time this restriction doesn't apply anymore, just define
- * CONFIG_SYS_ENABLE_SDRAM_CACHE in the board config file and this code should setup
+ * CONFIG_4xx_DCACHE in the board config file and this code should setup
* everything correctly.
*/
-#ifdef CONFIG_SYS_ENABLE_SDRAM_CACHE
+#ifdef CONFIG_4xx_DCACHE
#define MY_TLB_WORD2_I_ENABLE 0 /* enable caching on SDRAM */
#else
#define MY_TLB_WORD2_I_ENABLE TLB_WORD2_I_ENABLE /* disable caching on SDRAM */
program_tlb(0, CONFIG_SYS_SDRAM_BASE, CONFIG_SYS_MBYTES_SDRAM << 20,
MY_TLB_WORD2_I_ENABLE);
+#if defined(CONFIG_DDR_ECC)
+#if defined(CONFIG_4xx_DCACHE)
+ /*
+ * If ECC is enabled, initialize the parity bits.
+ */
+ program_ecc(0, CONFIG_SYS_MBYTES_SDRAM << 20, 0);
+#else /* CONFIG_4xx_DCACHE */
/*
* Setup 2nd TLB with same physical address but different virtual address
* with cache enabled. This is done for fast ECC generation.
*/
program_tlb(0, CONFIG_SYS_DDR_CACHED_ADDR, CONFIG_SYS_MBYTES_SDRAM << 20, 0);
-#ifdef CONFIG_DDR_ECC
/*
* If ECC is enabled, initialize the parity bits.
*/
program_ecc(CONFIG_SYS_DDR_CACHED_ADDR, CONFIG_SYS_MBYTES_SDRAM << 20, 0);
-#endif
+
+ /*
+ * Now after initialization (auto-calibration and ECC generation)
+ * remove the TLB entries with caches enabled and program again with
+ * desired cache functionality
+ */
+ remove_tlb(CONFIG_SYS_DDR_CACHED_ADDR, CONFIG_SYS_MBYTES_SDRAM << 20);
+#endif /* CONFIG_4xx_DCACHE */
+#endif /* CONFIG_DDR_ECC */
/*
* Clear possible errors resulting from data-eye-search.