powerpc: mpc85xx: Do not build errata command in SPL

[u-boot] / board / ronetix / pm9g45 / pm9g45.c

diff --git a/board/ronetix/pm9g45/pm9g45.c b/board/ronetix/pm9g45/pm9g45.c
index 15aa4acd1129e9ff344006da9422a4eebb2adb05..c2707e0015ddd433e5f806fecc1b50c55c96fc1a 100644 (file)
--- a/board/ronetix/pm9g45/pm9g45.c
+++ b/board/ronetix/pm9g45/pm9g45.c
@@ -17,7 +17,6 @@
 #include <asm/gpio.h>
 #include <asm/arch/at91sam9_smc.h>
 #include <asm/arch/at91_common.h>
-#include <asm/arch/at91_pmc.h>
 #include <asm/arch/at91_rstc.h>
 #include <asm/arch/at91_matrix.h>
 #include <asm/arch/gpio.h>
@@ -39,7 +38,6 @@ static void pm9g45_nand_hw_init(void)
        unsigned long csa;
        struct at91_smc *smc = (struct at91_smc *)ATMEL_BASE_SMC;
        struct at91_matrix *matrix = (struct at91_matrix *)ATMEL_BASE_MATRIX;
-       struct at91_pmc *pmc = (struct at91_pmc *)ATMEL_BASE_PMC;
 
        /* Enable CS3 */
        csa = readl(&matrix->ccr[6]) | AT91_MATRIX_CSA_EBI_CS3A;
@@ -63,7 +61,7 @@ static void pm9g45_nand_hw_init(void)
                AT91_SMC_MODE_TDF_CYCLE(3),
                &smc->cs[3].mode);
 
-       writel(1 << ATMEL_ID_PIOC, &pmc->pcer);
+       at91_periph_clk_enable(ATMEL_ID_PIOC);
 
 #ifdef CONFIG_SYS_NAND_READY_PIN
        /* Configure RDY/BSY */
@@ -78,8 +76,6 @@ static void pm9g45_nand_hw_init(void)
 #ifdef CONFIG_MACB
 static void pm9g45_macb_hw_init(void)
 {
-       struct at91_pmc *pmc = (struct at91_pmc *)ATMEL_BASE_PMC;
-
        /*
         * PD2 enables the 50MHz oscillator for Ethernet PHY
         * 1 - enable
@@ -88,8 +84,7 @@ static void pm9g45_macb_hw_init(void)
        at91_set_pio_output(AT91_PIO_PORTD, 2, 1);
        at91_set_pio_value(AT91_PIO_PORTD, 2, 1); /* 1- enable, 0 - disable */
 
-       /* Enable clock */
-       writel(1 << ATMEL_ID_EMAC, &pmc->pcer);
+       at91_periph_clk_enable(ATMEL_ID_EMAC);
 
        /*
         * Disable pull-up on:
@@ -114,13 +109,10 @@ static void pm9g45_macb_hw_init(void)
 
 int board_early_init_f(void)
 {
-       struct at91_pmc *pmc = (struct at91_pmc *)ATMEL_BASE_PMC;
-
-       /* Enable clocks for all PIOs */
-       writel((1 << ATMEL_ID_PIOA) |
-               (1 << ATMEL_ID_PIOB) |
-               (1 << ATMEL_ID_PIOC) |
-               (1 << ATMEL_ID_PIODE), &pmc->pcer);
+       at91_periph_clk_enable(ATMEL_ID_PIOA);
+       at91_periph_clk_enable(ATMEL_ID_PIOB);
+       at91_periph_clk_enable(ATMEL_ID_PIOC);
+       at91_periph_clk_enable(ATMEL_ID_PIODE);
 
        at91_seriald_hw_init();
 
@@ -166,7 +158,7 @@ void reset_phy(void)
         * Initialize ethernet HW addr prior to starting Linux,
         * needed for nfsroot
         */
-       eth_init(gd->bd);
+       eth_init();
 #endif
 }
 #endif