Merge branch 'master' of git://git.denx.de/u-boot-sunxi

[u-boot] / board / wandboard / README

diff --git a/board/wandboard/README b/board/wandboard/README
index ce83bbe4c5ebc87c823811e95eef424705ef39a1..6345416b2ff6becc659229ad5ca3ae3bee3e5112 100644 (file)
--- a/board/wandboard/README
+++ b/board/wandboard/README
@@ -3,38 +3,37 @@ U-Boot for Wandboard
 
 This file contains information for the port of U-Boot to the Wandboard.
 
-Wandboard is a development board that has two variants: one version based
-on mx6 dual lite and another one based on mx6 solo.
+Wandboard is a development board that has three variants based on the following
+SoCs: mx6 quad, mx6 dual lite and mx6 solo.
 
 For more details about Wandboard, please refer to:
 http://www.wandboard.org/
 
-Building U-boot for Wandboard
+Building U-Boot for Wandboard
 -----------------------------
 
-To build U-Boot for the Wandboard Dual Lite version:
+To build U-Boot for the Wandboard:
 
-$ make wandboard_dl_config
+$ make wandboard_config
 $ make
 
-To build U-Boot for the Wandboard Solo version:
-
-$ make wandboard_solo_config
-$ make
-
-Flashing U-boot into the SD card
+Flashing U-Boot into the SD card
 --------------------------------
 
-- After the 'make' command completes, the generated 'u-boot.imx' binary must be
+- After the 'make' command completes, the generated 'SPL' binary must be
 flashed into the SD card;
 
-$ sudo dd if=u-boot.imx of=/dev/mmcblk0 bs=512 seek=2; sync
+$ sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync
 
 (Note - the SD card node may vary, so adjust this as needed).
 
+- Flash the u-boot.img image into the SD card:
+
+sudo dd if=u-boot.img of=/dev/mmcblk0 bs=1k seek=69; sync
+
 - Insert the SD card into the slot located in the bottom of the board (same side
 as the mx6 processor)
 
 - Connect the serial cable to the host PC
 
-- Power up the board and U-boot messages will appear in the serial console.
+- Power up the board and U-Boot messages will appear in the serial console.