This file contains information for the port of U-Boot to the Wandboard.
-Wandboard is a development board that has two variants: one version based
-on mx6 dual lite and another one based on mx6 solo.
+Wandboard is a development board that has three variants based on the following
+SoCs: mx6 quad, mx6 dual lite and mx6 solo.
For more details about Wandboard, please refer to:
http://www.wandboard.org/
-Building U-boot for Wandboard
+Building U-Boot for Wandboard
-----------------------------
-To build U-Boot for the Wandboard Dual Lite version:
+To build U-Boot for the Wandboard:
-$ make wandboard_dl_config
+$ make wandboard_config
$ make
-To build U-Boot for the Wandboard Solo version:
-
-$ make wandboard_solo_config
-$ make
-
-Flashing U-boot into the SD card
+Flashing U-Boot into the SD card
--------------------------------
-- After the 'make' command completes, the generated 'u-boot.imx' binary must be
+- After the 'make' command completes, the generated 'SPL' binary must be
flashed into the SD card;
-$ sudo dd if=u-boot.imx of=/dev/mmcblk0 bs=512 seek=2; sync
+$ sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync
(Note - the SD card node may vary, so adjust this as needed).
+- Flash the u-boot.img image into the SD card:
+
+sudo dd if=u-boot.img of=/dev/mmcblk0 bs=1k seek=69; sync
+
- Insert the SD card into the slot located in the bottom of the board (same side
as the mx6 processor)
- Connect the serial cable to the host PC
-- Power up the board and U-boot messages will appear in the serial console.
+- Power up the board and U-Boot messages will appear in the serial console.