* 23 = #LED_STATUS1
* 24 = #LED_STATUS2
*/
- mfsdr(sdr_pfc0, sdrreg);
- mtsdr(sdr_pfc0, (sdrreg & ~SDR0_PFC0_TRE_ENABLE) | 0x00003e00);
+ mfsdr(SDR0_PFC0, sdrreg);
+ mtsdr(SDR0_PFC0, (sdrreg & ~SDR0_PFC0_TRE_ENABLE) | 0x00003e00);
out32(CONFIG_SYS_GPIO_BASE + 0x018, (USR_LED0 | USR_LED1 | USR_LED2 | USR_LED3));
LED0_OFF();
LED1_OFF();
LED3_OFF();
/* Setup the external bus controller/chip selects */
- mtebc(pb0ap, 0x04055200); /* 16MB Strata FLASH */
- mtebc(pb0cr, 0xff098000); /* BAS=0xff0 16MB R/W 8-bit */
- mtebc(pb1ap, 0x04055200); /* 512KB Socketed AMD FLASH */
- mtebc(pb1cr, 0xfe018000); /* BAS=0xfe0 1MB R/W 8-bit */
- mtebc(pb6ap, 0x05006400); /* 32-64MB AMD MirrorBit FLASH */
- mtebc(pb6cr, 0xf00da000); /* BAS=0xf00 64MB R/W i6-bit */
- mtebc(pb7ap, 0x05006400); /* 32-64MB AMD MirrorBit FLASH */
- mtebc(pb7cr, 0xf40da000); /* BAS=0xf40 64MB R/W 16-bit */
+ mtebc(PB0AP, 0x04055200); /* 16MB Strata FLASH */
+ mtebc(PB0CR, 0xff098000); /* BAS=0xff0 16MB R/W 8-bit */
+ mtebc(PB1AP, 0x04055200); /* 512KB Socketed AMD FLASH */
+ mtebc(PB1CR, 0xfe018000); /* BAS=0xfe0 1MB R/W 8-bit */
+ mtebc(PB6AP, 0x05006400); /* 32-64MB AMD MirrorBit FLASH */
+ mtebc(PB6CR, 0xf00da000); /* BAS=0xf00 64MB R/W i6-bit */
+ mtebc(PB7AP, 0x05006400); /* 32-64MB AMD MirrorBit FLASH */
+ mtebc(PB7CR, 0xf40da000); /* BAS=0xf40 64MB R/W 16-bit */
/*
* Setup the interrupt controller polarities, triggers, etc.
* UIC2 UIC1
* UIC3 UIC2
*/
- mtdcr(uic1sr, 0xffffffff); /* clear all */
- mtdcr(uic1er, 0x00000000); /* disable all */
- mtdcr(uic1cr, 0x00000003); /* SMI & UIC1 crit are critical */
- mtdcr(uic1pr, 0xfffffe00); /* per ref-board manual */
- mtdcr(uic1tr, 0x01c00000); /* per ref-board manual */
- mtdcr(uic1vr, 0x00000001); /* int31 highest, base=0x000 */
- mtdcr(uic1sr, 0xffffffff); /* clear all */
-
- mtdcr(uic2sr, 0xffffffff); /* clear all */
- mtdcr(uic2er, 0x00000000); /* disable all */
- mtdcr(uic2cr, 0x00000000); /* all non-critical */
- mtdcr(uic2pr, 0xffffc0ff); /* per ref-board manual */
- mtdcr(uic2tr, 0x00ff8000); /* per ref-board manual */
- mtdcr(uic2vr, 0x00000001); /* int31 highest, base=0x000 */
- mtdcr(uic2sr, 0xffffffff); /* clear all */
-
- mtdcr(uic3sr, 0xffffffff); /* clear all */
- mtdcr(uic3er, 0x00000000); /* disable all */
- mtdcr(uic3cr, 0x00000000); /* all non-critical */
- mtdcr(uic3pr, 0xffffffff); /* per ref-board manual */
- mtdcr(uic3tr, 0x00ff8c0f); /* per ref-board manual */
- mtdcr(uic3vr, 0x00000001); /* int31 highest, base=0x000 */
- mtdcr(uic3sr, 0xffffffff); /* clear all */
-
- mtdcr(uic0sr, 0xfc000000); /* clear all */
- mtdcr(uic0er, 0x00000000); /* disable all */
- mtdcr(uic0cr, 0x00000000); /* all non-critical */
- mtdcr(uic0pr, 0xfc000000); /* */
- mtdcr(uic0tr, 0x00000000); /* */
- mtdcr(uic0vr, 0x00000001); /* */
+ mtdcr(UIC1SR, 0xffffffff); /* clear all */
+ mtdcr(UIC1ER, 0x00000000); /* disable all */
+ mtdcr(UIC1CR, 0x00000003); /* SMI & UIC1 crit are critical */
+ mtdcr(UIC1PR, 0xfffffe00); /* per ref-board manual */
+ mtdcr(UIC1TR, 0x01c00000); /* per ref-board manual */
+ mtdcr(UIC1VR, 0x00000001); /* int31 highest, base=0x000 */
+ mtdcr(UIC1SR, 0xffffffff); /* clear all */
+
+ mtdcr(UIC2SR, 0xffffffff); /* clear all */
+ mtdcr(UIC2ER, 0x00000000); /* disable all */
+ mtdcr(UIC2CR, 0x00000000); /* all non-critical */
+ mtdcr(UIC2PR, 0xffffc0ff); /* per ref-board manual */
+ mtdcr(UIC2TR, 0x00ff8000); /* per ref-board manual */
+ mtdcr(UIC2VR, 0x00000001); /* int31 highest, base=0x000 */
+ mtdcr(UIC2SR, 0xffffffff); /* clear all */
+
+ mtdcr(UIC3SR, 0xffffffff); /* clear all */
+ mtdcr(UIC3ER, 0x00000000); /* disable all */
+ mtdcr(UIC3CR, 0x00000000); /* all non-critical */
+ mtdcr(UIC3PR, 0xffffffff); /* per ref-board manual */
+ mtdcr(UIC3TR, 0x00ff8c0f); /* per ref-board manual */
+ mtdcr(UIC3VR, 0x00000001); /* int31 highest, base=0x000 */
+ mtdcr(UIC3SR, 0xffffffff); /* clear all */
+
+ mtdcr(UIC0SR, 0xfc000000); /* clear all */
+ mtdcr(UIC0ER, 0x00000000); /* disable all */
+ mtdcr(UIC0CR, 0x00000000); /* all non-critical */
+ mtdcr(UIC0PR, 0xfc000000); /* */
+ mtdcr(UIC0TR, 0x00000000); /* */
+ mtdcr(UIC0VR, 0x00000001); /* */
LED0_ON();
}
/*
+ * Override weak pci_pre_init()
+ *
* This routine is called just prior to registering the hose and gives
* the board the opportunity to check things. Returning a value of zero
* indicates that things are bad & PCI initialization should be aborted.
* (add regions, override default access routines, etc) or perform
* certain pre-initialization actions.
*/
-
#if defined(CONFIG_PCI)
int pci_pre_init(struct pci_controller * hose)
{
unsigned long strap;
/* See if we're supposed to setup the pci */
- mfsdr(sdr_sdstp1, strap);
+ mfsdr(SDR0_SDSTP1, strap);
if ((strap & 0x00010000) == 0)
return 0;
#if defined(CONFIG_SYS_PCI_FORCE_PCI_CONV)
- /* Setup System Device Register PCIX0_XCR */
- mfsdr(sdr_xcr, strap);
+ /* Setup System Device Register PCIL0_XCR */
+ mfsdr(SDR0_XCR, strap);
strap &= 0x0f000000;
- mtsdr(sdr_xcr, strap);
+ mtsdr(SDR0_XCR, strap);
#endif
return 1;
}
#endif /* defined(CONFIG_PCI) */
-#if defined(CONFIG_PCI) && defined(CONFIG_SYS_PCI_TARGET_INIT)
-/*
- * The bootstrap configuration provides default settings for the pci
- * inbound map (PIM). But the bootstrap config choices are limited and
- * may not be sufficient for a given board.
- */
-void pci_target_init(struct pci_controller * hose)
-{
- /* Disable everything */
- out32r(PCIX0_PIM0SA, 0);
- out32r(PCIX0_PIM1SA, 0);
- out32r(PCIX0_PIM2SA, 0);
- out32r(PCIX0_EROMBA, 0); /* disable expansion rom */
-
- /*
- * Map all of SDRAM to PCI address 0x0000_0000. Note that the 440 strapping
- * options to not support sizes such as 128/256 MB.
- */
- out32r(PCIX0_PIM0LAL, CONFIG_SYS_SDRAM_BASE);
- out32r(PCIX0_PIM0LAH, 0);
- out32r(PCIX0_PIM0SA, ~(gd->ram_size - 1) | 1);
-
- out32r(PCIX0_BAR0, 0);
-
- /* Program the board's subsystem id/vendor id */
- out16r(PCIX0_SBSYSVID, CONFIG_SYS_PCI_SUBSYS_VENDORID);
- out16r(PCIX0_SBSYSID, CONFIG_SYS_PCI_SUBSYS_DEVICEID);
-
- out16r(PCIX0_CMD, in16r(PCIX0_CMD) | PCI_COMMAND_MEMORY);
-}
-#endif /* defined(CONFIG_PCI) && defined(CONFIG_SYS_PCI_TARGET_INIT) */
-
#if defined(CONFIG_PCI)
/*
+ * Override weak is_pci_host()
+ *
* This routine is called to determine if a pci scan should be
* performed. With various hardware environments (especially cPCI and
* PPMC) it's insufficient to depend on the state of the arbiter enable
projects / u-boot / blobdiff