#include <asm/processor.h>
#include <spd_sdram.h>
#include <i2c.h>
+#include <net.h>
DECLARE_GLOBAL_DATA_PTR;
/* TBS: Setup the GPIO access for the user LEDs */
mfsdr(sdr_pfc0, sdrreg);
mtsdr(sdr_pfc0, (sdrreg & ~0x00000100) | 0x00000E00);
- out32(CFG_GPIO_BASE + 0x018, (USR_LED0 | USR_LED1 | USR_LED2 | USR_LED3));
+ out32(CONFIG_SYS_GPIO_BASE + 0x018, (USR_LED0 | USR_LED1 | USR_LED2 | USR_LED3));
LED0_OFF();
LED1_OFF();
LED2_OFF();
/*--------------------------------------------------------------------
* Setup the external bus controller/chip selects
*-------------------------------------------------------------------*/
-
- /* set the bus controller */
- mtebc (pb0ap, 0x04055200); /* FLASH/SRAM */
- mtebc (pb0cr, 0xfff18000); /* BAS=0xfff 1MB R/W 8-bit */
- mtebc (pb1ap, 0x04055200); /* FLASH/SRAM */
- mtebc (pb1cr, 0xfe098000); /* BAS=0xff8 16MB R/W 8-bit */
+ mtebc (pb0ap, 0x04055200); /* 16MB Strata FLASH */
+ mtebc (pb0cr, 0xff098000); /* BAS=0xff0 16MB R/W 8-bit */
+ mtebc (pb1ap, 0x04055200); /* 512KB Socketed AMD FLASH */
+ mtebc (pb1cr, 0xfe018000); /* BAS=0xfe0 1MB R/W 8-bit */
/*--------------------------------------------------------------------
* Setup the interrupt controller polarities, triggers, etc.
*-------------------------------------------------------------------*/
- mtdcr (uic0sr, 0xffffffff); /* clear all */
- mtdcr (uic0er, 0x00000000); /* disable all */
- mtdcr (uic0cr, 0x00000003); /* SMI & UIC1 crit are critical */
- mtdcr (uic0pr, 0xfffffe00); /* per ref-board manual */
- mtdcr (uic0tr, 0x01c00000); /* per ref-board manual */
- mtdcr (uic0vr, 0x00000001); /* int31 highest, base=0x000 */
- mtdcr (uic0sr, 0xffffffff); /* clear all */
-
+ /*
+ * Because of the interrupt handling rework to handle 440GX interrupts
+ * with the common code, we needed to change names of the UIC registers.
+ * Here the new relationship:
+ *
+ * U-Boot name 440GX name
+ * -----------------------
+ * UIC0 UICB0
+ * UIC1 UIC0
+ * UIC2 UIC1
+ * UIC3 UIC2
+ */
mtdcr (uic1sr, 0xffffffff); /* clear all */
mtdcr (uic1er, 0x00000000); /* disable all */
- mtdcr (uic1cr, 0x00000000); /* all non-critical */
- mtdcr (uic1pr, 0xffffc0ff); /* per ref-board manual */
- mtdcr (uic1tr, 0x00ff8000); /* per ref-board manual */
+ mtdcr (uic1cr, 0x00000003); /* SMI & UIC1 crit are critical */
+ mtdcr (uic1pr, 0xfffffe00); /* per ref-board manual */
+ mtdcr (uic1tr, 0x01c00000); /* per ref-board manual */
mtdcr (uic1vr, 0x00000001); /* int31 highest, base=0x000 */
mtdcr (uic1sr, 0xffffffff); /* clear all */
mtdcr (uic2sr, 0xffffffff); /* clear all */
mtdcr (uic2er, 0x00000000); /* disable all */
mtdcr (uic2cr, 0x00000000); /* all non-critical */
- mtdcr (uic2pr, 0xffffffff); /* per ref-board manual */
- mtdcr (uic2tr, 0x00ff8c0f); /* per ref-board manual */
+ mtdcr (uic2pr, 0xffffc0ff); /* per ref-board manual */
+ mtdcr (uic2tr, 0x00ff8000); /* per ref-board manual */
mtdcr (uic2vr, 0x00000001); /* int31 highest, base=0x000 */
mtdcr (uic2sr, 0xffffffff); /* clear all */
- mtdcr (uicb0sr, 0xfc000000); /* clear all */
- mtdcr (uicb0er, 0x00000000); /* disable all */
- mtdcr (uicb0cr, 0x00000000); /* all non-critical */
- mtdcr (uicb0pr, 0xfc000000); /* */
- mtdcr (uicb0tr, 0x00000000); /* */
- mtdcr (uicb0vr, 0x00000001); /* */
+ mtdcr (uic3sr, 0xffffffff); /* clear all */
+ mtdcr (uic3er, 0x00000000); /* disable all */
+ mtdcr (uic3cr, 0x00000000); /* all non-critical */
+ mtdcr (uic3pr, 0xffffffff); /* per ref-board manual */
+ mtdcr (uic3tr, 0x00ff8c0f); /* per ref-board manual */
+ mtdcr (uic3vr, 0x00000001); /* int31 highest, base=0x000 */
+ mtdcr (uic3sr, 0xffffffff); /* clear all */
+
+ mtdcr (uic0sr, 0xfc000000); /* clear all */
+ mtdcr (uic0er, 0x00000000); /* disable all */
+ mtdcr (uic0cr, 0x00000000); /* all non-critical */
+ mtdcr (uic0pr, 0xfc000000); /* */
+ mtdcr (uic0tr, 0x00000000); /* */
+ mtdcr (uic0vr, 0x00000001); /* */
LED0_ON();
}
-long int initdram (int board_type)
+phys_size_t initdram (int board_type)
{
long dram_size = 0;
return dram_size;
}
-
-#if defined(CFG_DRAM_TEST)
-int testdram (void)
-{
- uint *pstart = (uint *) 0x00000000;
- uint *pend = (uint *) 0x08000000;
- uint *p;
-
- for (p = pstart; p < pend; p++)
- *p = 0xaaaaaaaa;
-
- for (p = pstart; p < pend; p++) {
- if (*p != 0xaaaaaaaa) {
- printf ("SDRAM test fails at: %08x\n", (uint) p);
- return 1;
- }
- }
-
- for (p = pstart; p < pend; p++)
- *p = 0x55555555;
-
- for (p = pstart; p < pend; p++) {
- if (*p != 0x55555555) {
- printf ("SDRAM test fails at: %08x\n", (uint) p);
- return 1;
- }
- }
- return 0;
-}
-#endif
-
#if !defined(CONFIG_SPD_EEPROM)
/*************************************************************************
* fixed sdram init -- doesn't use serial presence detect.
return (0);
}
-#if defined(CFG_PCI_FORCE_PCI_CONV)
+#if defined(CONFIG_SYS_PCI_FORCE_PCI_CONV)
/* Setup System Device Register PCIX0_XCR */
mfsdr(sdr_xcr, strap);
strap &= 0x0f000000;
* may not be sufficient for a given board.
*
************************************************************************/
-#if defined(CONFIG_PCI) && defined(CFG_PCI_TARGET_INIT)
+#if defined(CONFIG_PCI) && defined(CONFIG_SYS_PCI_TARGET_INIT)
void pci_target_init(struct pci_controller * hose )
{
/*--------------------------------------------------------------------------+
* Map all of SDRAM to PCI address 0x0000_0000. Note that the 440 strapping
* options to not support sizes such as 128/256 MB.
*--------------------------------------------------------------------------*/
- out32r( PCIX0_PIM0LAL, CFG_SDRAM_BASE );
+ out32r( PCIX0_PIM0LAL, CONFIG_SYS_SDRAM_BASE );
out32r( PCIX0_PIM0LAH, 0 );
out32r( PCIX0_PIM0SA, ~(gd->ram_size - 1) | 1 );
/*--------------------------------------------------------------------------+
* Program the board's subsystem id/vendor id
*--------------------------------------------------------------------------*/
- out16r( PCIX0_SBSYSVID, CFG_PCI_SUBSYS_VENDORID );
- out16r( PCIX0_SBSYSID, CFG_PCI_SUBSYS_DEVICEID );
+ out16r( PCIX0_SBSYSVID, CONFIG_SYS_PCI_SUBSYS_VENDORID );
+ out16r( PCIX0_SBSYSID, CONFIG_SYS_PCI_SUBSYS_DEVICEID );
out16r( PCIX0_CMD, in16r(PCIX0_CMD) | PCI_COMMAND_MEMORY );
}
-#endif /* defined(CONFIG_PCI) && defined(CFG_PCI_TARGET_INIT) */
+#endif /* defined(CONFIG_PCI) && defined(CONFIG_SYS_PCI_TARGET_INIT) */
/*************************************************************************
#if defined(CONFIG_PCI)
int is_pci_host(struct pci_controller *hose)
{
- return ((in32(CFG_GPIO_BASE + 0x1C) & 0x00000800) == 0);
+ return ((in32(CONFIG_SYS_GPIO_BASE + 0x1C) & 0x00000800) == 0);
}
#endif /* defined(CONFIG_PCI) */
void post_word_store (ulong a)
{
volatile ulong *save_addr =
- (volatile ulong *)(CFG_POST_WORD_ADDR);
+ (volatile ulong *)(CONFIG_SYS_POST_WORD_ADDR);
*save_addr = a;
}
ulong post_word_load (void)
{
volatile ulong *save_addr =
- (volatile ulong *)(CFG_POST_WORD_ADDR);
+ (volatile ulong *)(CONFIG_SYS_POST_WORD_ADDR);
return *save_addr;
}
* board_get_enetaddr -- Read the MAC Addresses in the I2C EEPROM
*-----------------------------------------------------------------------------
*/
-static int enetaddr_num = 0;
-void board_get_enetaddr (uchar * enet)
+static int read_i2c;
+static void board_get_enetaddr(uchar *enet)
{
int i;
unsigned char buff[0x100], *cp;
+ if (read_i2c)
+ return;
+
/* Initialize I2C */
- i2c_init (CFG_I2C_SPEED, CFG_I2C_SLAVE);
+ i2c_init (CONFIG_SYS_I2C_SPEED, CONFIG_SYS_I2C_SLAVE);
/* Read 256 bytes in EEPROM */
i2c_read (0x50, 0, 1, buff, 0x100);
- if (enetaddr_num == 0) {
- cp = &buff[0xF4];
- enetaddr_num = 1;
- }
- else
- cp = &buff[0xFA];
-
+ cp = &buff[0xF4];
for (i = 0; i < 6; i++,cp++)
enet[i] = *cp;
- printf ("MAC address = %02x:%02x:%02x:%02x:%02x:%02x\n",
- enet[0], enet[1], enet[2], enet[3], enet[4], enet[5]);
+ printf("MAC address = %pM\n", enet);
+ read_i2c = 1;
+}
+
+int misc_init_r(void)
+{
+ uchar enetaddr[6], i2c_enetaddr[6];
+
+ if (!eth_getenv_enetaddr("ethaddr", enetaddr)) {
+ board_get_enetaddr(i2c_enetaddr);
+ eth_setenv_enetaddr("ethaddr", i2c_enetaddr);
+ }
+
+#ifdef CONFIG_HAS_ETH1
+ if (!eth_getenv_enetaddr("eth1addr", enetaddr)) {
+ board_get_enetaddr(i2c_enetaddr);
+ eth_setenv_enetaddr("eth1addr", i2c_enetaddr);
+ }
+#endif
+
+#ifdef CONFIG_HAS_ETH2
+ if (!eth_getenv_enetaddr("eth2addr", enetaddr)) {
+ board_get_enetaddr(i2c_enetaddr);
+ eth_setenv_enetaddr("eth2addr", i2c_enetaddr);
+ }
+#endif
+
+#ifdef CONFIG_HAS_ETH3
+ if (!eth_getenv_enetaddr("eth3addr", enetaddr)) {
+ board_get_enetaddr(i2c_enetaddr);
+ eth_setenv_enetaddr("eth3addr", i2c_enetaddr);
+ }
+#endif
+ return 0;
}