endmenu
-source "cmd/fastboot/Kconfig"
-
config BUILD_BIN2C
bool
config CMD_BOOTEFI_HELLO_COMPILE
bool "Compile a standard EFI hello world binary for testing"
- depends on CMD_BOOTEFI && (ARM || X86)
+ depends on CMD_BOOTEFI && (ARM || X86 || RISCV)
default y
help
This compiles a standard EFI hello world application with U-Boot so
can be useful to see the state of driver model for debugging or
interest.
+config CMD_FASTBOOT
+ bool "fastboot - Android fastboot support"
+ depends on FASTBOOT
+ help
+ This enables the command "fastboot" which enables the Android
+ fastboot mode for the platform. Fastboot is a protocol for
+ downloading images, flashing and device control used on
+ Android devices. Fastboot requires either the network stack
+ enabled or support for acting as a USB device.
+
+ See doc/README.android-fastboot for more information.
+
config CMD_FDC
bool "fdcboot - Boot from floppy device"
help
Supports loading an FPGA device from a bitstream buffer containing
a partial bitstream.
+config CMD_FPGA_LOAD_SECURE
+ bool "fpga loads - loads secure bitstreams (Xilinx only)"
+ depends on CMD_FPGA
+ help
+ Enables the fpga loads command which is used to load secure
+ (authenticated or encrypted or both) bitstreams on to FPGA.
+
config CMD_FPGAD
bool "fpgad - dump FPGA registers"
help
Enable the commands for reading, writing and programming the
key for the Replay Protection Memory Block partition in eMMC.
+config CMD_MMC_SWRITE
+ bool "mmc swrite"
+ depends on CMD_MMC && MMC_WRITE
+ select IMAGE_SPARSE
+ help
+ Enable support for the "mmc swrite" command to write Android sparse
+ images to eMMC.
+
config CMD_NAND
bool "nand"
default y if NAND_SUNXI